Not to sure what the offset is

Diegoestevan

I just picked up these wheels. The front is a 20x9 with a +30. Curious if it should be poking out as shown with a +30, maybe it's a lower offset? Car is stock height.

Sent from my SAMSUNG-SM-N920A using Tapatalk

jchammond

They do look a bit further out; remove one & look inside back of wheel for specs...they should be posted; also while wheel is off...put a straight edge across wheel only & should have just over 6” of backspacing

__________________
MazWorx built long block | FI-TT-100 Stage 2.75 | IPT built 7A/T

http://www.the370z.com/members-370z-...s-musings.html

Diegoestevan

The wheels do not show specs for offset just E.T and a blank stamp, i check. They were drilled to the bolt pattern and shave down to +30, as requested. I'm guessing that's why they leave the stamp blank. The box did say 20x9 and +30 when received though. I don't follow what you mean for the backspacing though, what do you mean?

Sent from my SAMSUNG-SM-N920A using Tapatalk

jchammond

Okay; beings you have a good view from outside- place a straight edge across outer wheel lip & then measure distance to the rotor mount flange...(where wheel contacts rotor) should be just over 3.75”

__________________
MazWorx built long block | FI-TT-100 Stage 2.75 | IPT built 7A/T

http://www.the370z.com/members-370z-...s-musings.html

Diegoestevan

So I can do that with the wheel on the vehicle is what you're saying? Just lay a board across wheel and measure to where the wheel meets hub? If it doesn't measure that, what should I assume?

Sent from my SAMSUNG-SM-N920A using Tapatalk

OptionZero

There's an easier way to do this that doesn't involve measuring

https://shop.klutchrepublik.com/coll...3-glossy-black

Look at the sizes this comes in. There's only a handful of sizes, and even fewer in 5x114.3

There is no 20x9 +30

They could be 20x10 +25 all around, just from how they set

Also, they are ugly as sin. Please take them off and demand a refund from whoever you bought them from
They appear to be multi piece wheels in which the face protrudes out from the barrel. I cannot imagine who thins that looks good, thats the opposite of getting wheels for a fat lip

__________________
OptionZero Build Thread

Diegoestevan

No they were made to order, they we're the custom option, 20x9 5x114.3 and Idk but apparently a +30 at least what my store ordered. And I like the design, that's all that matters.

Sent from my SAMSUNG-SM-N920A using Tapatalk

OptionZero

if you know what store ordered the wheels . . . why can't you just ask them?

__________________
OptionZero Build Thread

Diegoestevan

These were brand new in box, I shouldn't have to tell you this but they have the specs on each side the rears were marked 20x11 +22, model, bore size, etc. And the fronts were marked 20x9 +30 etc. The reason for this post was to find out if this is what a 20x9 +30 should look like bc I didn't think it would poke out past the fender at all, these do a tad bit.

Sent from my SAMSUNG-SM-N920A using Tapatalk