Stillenized and UpRev'd

threeseventy · 01-03-2012, 02:44 PM

Decided on a Pre-holiday gift to myself, knowing I was getting sweaters and shoes.. again.

Stillen HFC's arrived from RCZ (most* of my engine bolt-ons are forum-bought, used, from fellow members) and they - along with Swift springs (New-Amplified) and lightweight 19" MAYA STM's went on at Amplified (Thanks Lou!) the day before I drove up to SpecialtyZ in Chatsworth to see Sebastian for the 5-map UpRev tune.

Engine Mods are:

Stillen G3 CAI's, ducted via hose from lower left bumper intake.
Stillen HFC's (RCZ)
Stillen Catback Exhaust (chuckd05)
*Stillen UD Pulley -purchased new from Stillen for safety.

Temps were hovering around 58-59 degrees. Pulls 5 and 6 were nearly identical. I can't emphasize enough the importance of a good Post-Mod tune, both from the performance standpoint and for the health and life of your engine. Case in point: the comparison/baseline pull was aborted at 6500 rpm by Seb to avoid damage because Z was breathing so freely she was running super-lean to the point where there was audible evidence of detonation:

No Drone at freeway speed with Fuel Save map active, sound is amazing in tunnels and the canyons, keeping her planted are:

Stillen V1 F/R Sways on stiffest setting (ZPirate)
Stillen front splitter (new from Stillen, sale priced, thanks Josh and Kyle- and Margaret)
Megan Racing traction arms (first forum buy..what was his name?)
The aforementioned MAYA STM 19x9.5/19x10.5's with RE050's (Super_Red_Z) and Titek Duralumin lugs from (Kenchan)

Also love the AMS Shortshifter and Blox 490 from The Shocker, now I just need my clutch and tranny to keep up (see below). And of course there was the AMAZING car audio upgrade week with BIGAUDIOFANAT(ic)

Coming this month - Ichiba 20mm rear spacers and SPL Pro Camber arms along with an alignment before the upcoming GMR Cruise and some stainless Goodridge brake lines from my favorite unofficial vendor RCZ.

I can't say enough about the friendly professional service I get at Amplified from Lou and his crew (referred by Jamaica@UndergroundAlliance) and from Sebastian at SpecialtyZ (Referred by Lou@amplified). I was at my Nissan Dealership yesterday getting a new (warranty!) Slave+Master and a Synthetic fill for my 6MT and I walked into the showroom to see if they had any Z's. They were sold out except for one black roadster, I talked to the wide-eyed young salesman on duty about how to sell Z's. My point was, with his other cars you get room for groceries, sporty looks, reliability.. but with the Z and this forum you get all of that PLUS a FAMILY of great knowledgeable people and endless hours, even days, of fun and enjoyment. AND THEN you get to DRIVE these great cars!

Jamaica · 01-03-2012, 02:48 PM

those are some good numbers.

toplessdottie · 01-03-2012, 02:50 PM

Congrats on the great numbers...... should share them with Stillen

'10Anamoly · 01-03-2012, 03:45 PM

Numbers are good but you need to show the SAE numbers, not the standard ones. The SAE are more realistic of actual output. Nice either way though, thats about 313whp in SAE which is pretty darn good.

Seb@SZ · 01-03-2012, 03:52 PM

Quote:

Originally Posted by '10Anamoly

Numbers are good but you need to show the SAE numbers, not the standard ones. The SAE are more realistic of actual output. Nice either way though, thats about 313whp in SAE which is pretty darn good.

315 whp SAE

chuckd05 · 01-03-2012, 04:12 PM

Nice to see my exhaust on another strong N/A Z !!

Congrats

Also, a lot of forum support for other manufacturers out there other than stillen but time after time and car after car the stillen bolt on cars make GREAT power. Zero regrets for Me going with there Intake, Catback, and Pulley.

Now I discovered what tourque is and with my n54 stillen doesn't make any products
Otherwise I'd be supporting them on my new platform.

370Z JT · 01-04-2012, 09:14 PM

Nice. Can't wait to get my car on their dyno next Wednesday.

RCZ · 01-05-2012, 07:22 PM

Very nice results! Glad I could help!

TerribleONE · 01-05-2012, 07:26 PM

Nice results!!

01-03-2012, 02:44 PM	#1 (permalink)
threeseventy Track Member Join Date: Mar 2011 Location: Huntington Beach, CA Posts: 600 Drives: Opinion Rep Power: 15	Stillenized and UpRev'd Decided on a Pre-holiday gift to myself, knowing I was getting sweaters and shoes.. again. Stillen HFC's arrived from RCZ (most* of my engine bolt-ons are forum-bought, used, from fellow members) and they - along with Swift springs (New-Amplified) and lightweight 19" MAYA STM's went on at Amplified (Thanks Lou!) the day before I drove up to SpecialtyZ in Chatsworth to see Sebastian for the 5-map UpRev tune. Engine Mods are: Stillen G3 CAI's, ducted via hose from lower left bumper intake. Stillen HFC's (RCZ) Stillen Catback Exhaust (chuckd05) Stillen UD Pulley -purchased new from Stillen for safety. Temps were hovering around 58-59 degrees. Pulls 5 and 6 were nearly identical. I can't emphasize enough the importance of a good Post-Mod tune, both from the performance standpoint and for the health and life of your engine. Case in point: the comparison/baseline pull was aborted at 6500 rpm by Seb to avoid damage because Z was breathing so freely she was running super-lean to the point where there was audible evidence of detonation: No Drone at freeway speed with Fuel Save map active, sound is amazing in tunnels and the canyons, keeping her planted are: Stillen V1 F/R Sways on stiffest setting (ZPirate) Stillen front splitter (new from Stillen, sale priced, thanks Josh and Kyle- and Margaret) Megan Racing traction arms (first forum buy..what was his name?) The aforementioned MAYA STM 19x9.5/19x10.5's with RE050's (Super_Red_Z) and Titek Duralumin lugs from (Kenchan) Also love the AMS Shortshifter and Blox 490 from The Shocker, now I just need my clutch and tranny to keep up (see below). And of course there was the AMAZING car audio upgrade week with BIGAUDIOFANAT(ic) Coming this month - Ichiba 20mm rear spacers and SPL Pro Camber arms along with an alignment before the upcoming GMR Cruise and some stainless Goodridge brake lines from my favorite unofficial vendor RCZ. I can't say enough about the friendly professional service I get at Amplified from Lou and his crew (referred by Jamaica@UndergroundAlliance) and from Sebastian at SpecialtyZ (Referred by Lou@amplified). I was at my Nissan Dealership yesterday getting a new (warranty!) Slave+Master and a Synthetic fill for my 6MT and I walked into the showroom to see if they had any Z's. They were sold out except for one black roadster, I talked to the wide-eyed young salesman on duty about how to sell Z's. My point was, with his other cars you get room for groceries, sporty looks, reliability.. but with the Z and this forum you get all of that PLUS a FAMILY of great knowledgeable people and endless hours, even days, of fun and enjoyment. AND THEN you get to DRIVE these great cars! Last edited by threeseventy; 01-08-2012 at 03:35 PM.*

01-03-2012, 02:50 PM	#3 (permalink)
toplessdottie Base Member Join Date: Oct 2011 Location: Dallas, TX Posts: 143 Drives: An Evil Monkey Rep Power: 14	Congrats on the great numbers...... should share them with Stillen __________________ Chris '70 Datsun 2000 Roadster '09 370z- Invidia, Stillen G3, ZEnclosure

01-03-2012, 03:45 PM	#4 (permalink)
'10Anamoly Track Member Join Date: May 2010 Location: GA Posts: 882 Drives: 2010 370Z BS M6 Rep Power: 16	Numbers are good but you need to show the SAE numbers, not the standard ones. The SAE are more realistic of actual output. Nice either way though, thats about 313whp in SAE which is pretty darn good. __________________ 2013 Ford Mustang GT 374rwhp, 360rwtq SAE / GT500 Axle-Backs / Brembo Pack / Track Pack / Recaros / 6spd

01-03-2012, 04:12 PM	#6 (permalink)
chuckd05 A True Z Fanatic Join Date: Oct 2009 Location: NY Posts: 2,391 Drives: No longer a Z Rep Power: 20	Nice to see my exhaust on another strong N/A Z !! Congrats Also, a lot of forum support for other manufacturers out there other than stillen but time after time and car after car the stillen bolt on cars make GREAT power. Zero regrets for Me going with there Intake, Catback, and Pulley. Now I discovered what tourque is and with my n54 stillen doesn't make any products Otherwise I'd be supporting them on my new platform. __________________ 09 370Z 6M PW - FBO Best 1/4 mile = 12.926 @ 109 SOLD -- 08 BMW 135i - FBO 12.1@120mph SOLD -- white 09 e92 335 Coupe Mtech - 11.9 @ 119 :-) Last edited by chuckd05; 01-03-2012 at 04:15 PM.

01-04-2012, 09:14 PM	#7 (permalink)
370Z JT A True Z Fanatic Join Date: Jan 2010 Location: United States Posts: 2,905 Drives: 370Z PW 7AT Rep Power: 378	Nice. Can't wait to get my car on their dyno next Wednesday. Silversport09 likes this. __________________ Click for My Journal Top Secret \| EVO-R \| Fujimura Auto \| Shine Auto \| Seibon \| MRWorks \| Swift \| SPC \| SSR \| UpRev \| Project Kics \| NST \| Titek \| Eibach \| Nismo \| Whiteline \| Quaife \| Invidia \| Fly1 \| CF Element \| Carbon Signal

01-03-2012, 02:48 PM	#2 (permalink)
Jamaica A True Z Fanatic Join Date: Mar 2010 Location: SoCal Posts: 15,362 Drives: Under boost Rep Power: 73	those are some good numbers.

01-05-2012, 07:22 PM	#8 (permalink)
RCZ A True Z Fanatic Join Date: Nov 2008 Location: Miami Posts: 6,403 Drives: '09 370Z Rep Power: 1119	Very nice results! Glad I could help!

01-05-2012, 07:26 PM	#9 (permalink)
TerribleONE A True Z Fanatic Join Date: Jan 2009 Location: Socal Posts: 10,203 Drives: WOT Rep Power: 5850	Nice results!! __________________ 638WHP 541WTQ @ 13.5PSI Build thread

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Have You Had Your Z/G UpRev'd Yet?	Anthony@PM	North East Region	0	05-07-2011 04:30 PM