I thought it was supposed to be easy!

ZoomZ

I wasn't going to let this thing defeat me.

The driver side popped right in. I had to trim about 3/16" on breather (driver side) to allow clearance from the Ignition coil and tube and a little on oil filler cap.

I exercised the clamps before install and it hooked up better and with enough thread engagement.

Passenger side, as i mentioned before, was something else. I'm in discussion with HPS on this and they've been really good. I'll see what they suggest after pictures are sent. I think i trimmed about 1/8 too much on breather.

On a side note. I went for a drive. Came back and checked on things. I found these tubes to be extremely soft due to the heat.

I can help but to think about the amount of possible collapse.

Any videos or thoughts on this?

Thanks for the help .

Attached Images

IMG_2995.jpg (118.2 KB, 13 views)