|
You want to weld on the bung on the downstream side of the collector so it would be near 6, 7, 8. From your picture, I'm guessing that's the driver
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
03-26-2019, 06:58 AM
|
#2 (permalink) |
|
Base Member
Join Date: Sep 2017
Location: Pittsburgh
Posts: 49
Drives: 18 370 ST Blue Pearl
Rep Power: 8  |
You want to weld on the bung on the downstream side of the collector so it would be near 6, 7, 8. From your picture, I'm guessing that's the driver side header. You will need to weld them between the 2 and 3 o'clock position because space is tight below the car (so opposite side from 9, 10, and 11). If you weld them any higher than that, there is a good chance you won't be able to get your O2 sensor in the bung.
I attached a picture of where I had mine welded on. I actually welded mine on the exhaust pipe because there was minimal room on my headers. Ignore my ghetto heatsink... I would recommend putting one bung on each side so that you can monitor each engine bank. |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wideband bung location on ART pipes? | Kamillio | Forced Induction | 7 | 09-07-2017 07:11 AM |
| Removing O2 sensor J extension bung on FI LTH | reynald3616 | Intake/Exhaust | 23 | 02-12-2017 01:18 AM |
| Extra Bung Necessary | 37zeroZ | Intake/Exhaust | 4 | 02-29-2016 05:53 PM |
| [FOR SALE] AAM Test Pipes with extra O2 bung welded in | Gregor12 | Parts for sale (Private Classifieds) | 7 | 10-24-2014 12:57 AM |
| ARF bung placement??? | Kirkster | Forced Induction | 22 | 06-22-2011 08:41 PM |
1Likes
Threaded Mode
