So my problem went from bad to worse. I sent out the 650's to be tested and cleaned and they came out perfect, even before cleaning they were good. At
|
|
LinkBack | Thread Tools | Display Modes |
05-27-2016, 09:02 PM | #1 (permalink) |
Base Member
Join Date: Aug 2014
Location: NH
Posts: 91
Drives: 2010 Nissan 370z
Rep Power: 11 |
Running on 3 cylinders..
So my problem went from bad to worse. I sent out the 650's to be tested and cleaned and they came out perfect, even before cleaning they were good. At the moment the car is running on 3 cylinders..now let me explain how we got to this...
I tested all the injector clips for voltage, 11.55 all across the board, next i tested the coil packs for power balance and this is where i saw issues. Cylinder 3,5,6 do not have any effect, on or off. However when i turn cyl 3 off the car idles up a little and then back to stumbling on its face. I have swapped coil packs between 2 and 6 and has no effects, still not working. I have cycled through the power balance phase multiple times hoping it was a blip, no luck. I also did a compression test and i was 220 all across the board...the air/fuel is pinned lean (20) on bank 1 and sits about 16 on bank 2..FPR is pegged at 53 off vac and 44ish on vac..any ideas? FI TT Kit, car was running fine until I installed the ID1300's and it had a slight skip at idle so I returned them. Put the 650's back after being cleaned and tested and now my car went from skipping to full blown retard mode...
__________________
2010 Nissan 370z F.I. TT |
05-28-2016, 08:16 AM | #2 (permalink) | |
Premium Member
Join Date: Nov 2010
Location: South Arkansas
Posts: 8,435
Drives: 2014 Challenger
Rep Power: 324198 |
Quote:
__________________
Steering Lock Links - Search The370Z Bookmarklet - FSM @ NICOclub Mankind has progressed past the need for war but we haven't evolved that far. - NachoMahma |
|
05-28-2016, 09:18 AM | #4 (permalink) |
A True Z Fanatic
Join Date: Nov 2014
Location: South Carolina
Age: 58
Posts: 15,204
Drives: 13’ 370Z TS 7A/T
Rep Power: 2684394 |
I'd Check for a bad connection on the main harness,for whichever bank isn't firing.
Sent from my iPhone using Tapatalk
__________________
MazWorx built long block | FI-TT-100 Stage 2.75 | IPT built 7A/T http://www.the370z.com/members-370z-...s-musings.html |
05-28-2016, 11:58 AM | #5 (permalink) |
Base Member
Join Date: Aug 2014
Location: NH
Posts: 91
Drives: 2010 Nissan 370z
Rep Power: 11 |
I ordered a new injector harness, I am going to run jumper harnesses this time around. Maybe when I disconnected the coolant lines running to the TB it got inside the connectors and corroded them..who knows
__________________
2010 Nissan 370z F.I. TT |
05-28-2016, 09:59 PM | #7 (permalink) |
Ronin Samurai - Assassin
Join Date: Dec 2011
Location: Fayettenam,Pennsyltucky
Age: 68
Posts: 35,172
Drives: 2011 Nismo GM 6M
Rep Power: 2684437 |
Run like champ now?
__________________
浪人 - 殺し屋 "The Difficult Anytime, The Impossible By Appointment Only" http://www.the370z.com/members-370z-...o-journal.html |
06-09-2016, 09:52 PM | #8 (permalink) |
Base Member
Join Date: Aug 2014
Location: NH
Posts: 91
Drives: 2010 Nissan 370z
Rep Power: 11 |
Yeah man just need to find a small leak somewhere in the wastegate vacuum mess..it seems to be a little unstable and inconsistent with boost pressure.
__________________
2010 Nissan 370z F.I. TT |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
370Z running on 5 cylinders, rough idle, no power | GEMu | Engine & Drivetrain | 13 | 06-19-2018 04:33 AM |
For those running the LED daytime running lights | Ni55anPat | Exterior & Interior | 0 | 05-04-2015 04:00 PM |
I think my oil is running a little hot.. | mrsleepy1225 | Engine & Drivetrain | 18 | 10-09-2010 02:18 PM |