Front lip install help

brianryan8 · 05-29-2012, 03:35 AM

Lip installment helP
Just got my top secret lip CF. BUT how should I install it?
Do I bolt I on using screws? If so then where???

Total noob so appreciate your help as always guys!!!
*

anthonyy · 05-29-2012, 01:36 PM

dual thread power

SmallermouseZ · 05-30-2012, 02:25 AM

If ur using screws, ur screwing it on and if ur using bolts, ur bolting it on.

kenchan · 05-30-2012, 11:41 AM

if there are no pre-drilled screw holes, just drill new holes. on my Ings, i made 3 holes in the center section and using the 2 holes on the sides where it was pre-drilled.

put your car on ramps and you will see that it's very easy to do.

you can source screws at acehardware. get bolts, locking nuts, and washers. still use the mounting tape as it will close up any gap and use the nuts/bolts to fasten to the bumper tightly. the torque should be snug, but dont over tighten. GL!

05-29-2012, 03:35 AM	#1 (permalink)
brianryan8 Base Member Join Date: Dec 2011 Location: Guam Posts: 22 Drives: 2012 370z M6 Rep Power: 13	Front lip install help Lip installment helP Just got my top secret lip CF. BUT how should I install it? Do I bolt I on using screws? If so then where??? Total noob so appreciate your help as always guys!!! *

05-30-2012, 11:41 AM	#4 (permalink)
kenchan A True Z Fanatic Join Date: Aug 2009 Location: N/A Posts: 76,801 Drives: N/A Rep Power: 141521	if there are no pre-drilled screw holes, just drill new holes. on my Ings, i made 3 holes in the center section and using the 2 holes on the sides where it was pre-drilled. put your car on ramps and you will see that it's very easy to do. you can source screws at acehardware. get bolts, locking nuts, and washers. still use the mounting tape as it will close up any gap and use the nuts/bolts to fasten to the bumper tightly. the torque should be snug, but dont over tighten. GL! BeemaaZ likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DIY: STILLEN 370Z Front Splitter Install	TypeOne	DIY Section (Do-It-Yourself)	37	01-25-2014 04:37 PM
Kinetix Front Camber Arms Install	pokeyl	Brakes & Suspension	16	10-16-2012 03:26 PM
Is there a DIY for front SPC Camber arms install?	TMAN1985	Brakes & Suspension	9	02-27-2012 05:23 AM
Front bumper foglight install	MY1STZ	Exterior & Interior	3	09-12-2010 10:02 AM

05-29-2012, 01:36 PM	#2 (permalink)
anthonyy A True Z Fanatic Join Date: Apr 2011 Location: Los Gatos, CA Posts: 1,027 Drives: Lexus CT Rep Power: 16	dual thread power

05-30-2012, 02:25 AM	#3 (permalink)
SmallermouseZ Enthusiast Member Join Date: Oct 2011 Location: Vancouver Posts: 368 Drives: 2012pw 6mt sport/nav Rep Power: 14	If ur using screws, ur screwing it on and if ur using bolts, ur bolting it on.