|
Hello all! I hope everyone is doing well out there! I just installed my Nismo 2015+ front bumper on my 2011 370Z! However, I had to remove the polystyrene foam
|
|||||||
 |
|
|
LinkBack | Thread Tools | Display Modes |
08-11-2020, 07:07 PM
|
#1 (permalink) |
|
Base Member
Join Date: Aug 2017
Location: Austin, TX
Posts: 1
Drives: 2011 Nissan 370z
Rep Power: 8  |
Foam Absorber Not Fitting with Nismo 15+ Front Bumper Conversion
Hello all!
I hope everyone is doing well out there! I just installed my Nismo 2015+ front bumper on my 2011 370Z! However, I had to remove the polystyrene foam absorber in order to make it fit properly. Has anyone else run into this issue or found a workaround to this? Any help and support would be much appreciated! I would prefer to have the foam absorber in there so that the crumple zones can work as intended for front-end collisions. I'm also a tad bit concerned that it'll expose my cold air intake to water during wet seasons. Cheers! H |
|
|
|
08-11-2020, 07:25 PM
|
#2 (permalink) |
|
Elite Member
 
Join Date: Jun 2012
Location: Calgary
Posts: 13,973
Drives: 14 PW 370Z S/T MT
Rep Power: 243722  |
Should be able to use it. Everyone else has. 1st post on this page and down for further discussion.
2015 Nismo Bumper on 2009 Sport possible?
__________________
 Member of kenchan's "photoshopped mods" and "proper offsets" gang.
|
|
|
|
|
08-16-2020, 10:30 PM
|
#3 (permalink) |
|
A True Z Fanatic
Join Date: Jun 2011
Location: Madison, WI
Posts: 1,397
Drives: 2009 370Z
Rep Power: 16804 |
How far was it from fitting? I didn't notice any problem with keeping it in, but wondering if you are more perceptive to deflection than I am.
__________________
@stupidtoycars | My track vids 09 7AT|MCS 2WNR|Topgunz Rotrex|Ecutek (Eugene)|Maxxis RC1|Titan-7 TS-5|OSG LSD|Rear Mount Derale Oil Cooler (WIP)+25 Trans Cooler|Fismo|G-LOC R12/R10|Zeta III L|NLR Wing and Splitter|CJM Pan and Fuel Hat|Radium Surge Tank|AP Racing CP9668 |
|
|
|
|
08-16-2020, 11:48 PM
|
#4 (permalink) |
|
Elite Member
Join Date: Jun 2012
Location: Calgary
Posts: 13,973
Drives: 14 PW 370Z S/T MT
Rep Power: 243722 |
I am hoping the OP figured it out, since there was no further reply.
__________________
Member of kenchan's "photoshopped mods" and "proper offsets" gang.
Last edited by cooltoy; 08-17-2020 at 12:06 AM. |
|
|
|
|
08-17-2020, 03:45 AM
|
#5 (permalink) |
|
Base Member
Join Date: Mar 2018
Location: Des Moines, Iowa
Posts: 168
Drives: 2014 370z Nismo
Rep Power: 7051 |
Buy a Nismo...
__________________
2014 370z Nismo Fairlady | Gold Powdercoated Nismo Rays | Z1 Ported Manifold | RJM Adjustable Clutch Pedal | Berk Test Pipes | Beluga Racing Exhaust | Custom Billetworkz Imperial Sledge Shift Knob | Carbon Fiber, Flat-Bottom Steering Wheel | Ecu-Tek Custom Tune
|
|
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FYI. 2010 nismo Front bumper conversion | Z34_TDogg | Nissan 370Z General Discussions | 27 | 08-21-2020 03:22 PM |
| [WTB] 15+ Front Nismo Bumper Conversion Parts | litesky | Parts for sale (Private Classifieds) | 0 | 05-24-2019 12:16 PM |
| How much does it cost to do a full 2015+ front bumper Nismo conversion? | ZSerg | Exterior & Interior | 8 | 10-09-2018 09:14 PM |
| [FOR SALE] TX: Seibon BD Hood, 2015 Nismo Front Bumper Conversion | Boost_lee | Parts for sale (Private Classifieds) | 28 | 09-07-2016 01:48 AM |
| [FOR SALE] 370z nismo front bumper conversion | cor240sx90 | Parts for sale (Private Classifieds) | 43 | 07-27-2014 08:57 PM |
2Likes
Linear Mode
