Calling all clutch bleeding experts

Rangerz

Motul RBF 600 and its either hardline or stainless tubing. Very similar in looks to the Z speed CSC.

same issue today at the track. It feels like after the compression stroke it back fills really slowly and as the heat builds in the session it lasts longer. After the cooldown lap it is stiff as can be though WTF?

I think Rusty might have it pegged though air in the MC.

FSM says not to presure bleed it but, not sure what else I can do. I guess I could pull it back out and bleed/fill it on the bench.

One good thing I was able to beat my best time again on the outer track.

__________________
Stillen Gen III/ NST/ Fast Intentions Non-Res HFC & 12" Resonated CF TDX/ Setreb series 9 OC/ SPL upper control arms/ Whiteline front & rear swaybars/ Uprev tuned by Seb@specialtyZ/ 319HP 262TQ/ Z1 PS Cooler/ Z1 SS Premium break lines/ CJM Road Race pump/Carbotech F:XP10 R:XP8 Nismo OC DIY

Juan@Fontana

from the sound of things you are boiling over the clutch fluid, wrap the line in some DEI heat reflective wrap, wrap your testpipes / cat's with some additional heat shielding and bleed your clutch using either Endless RF650 or OE Nissan GTR Brake fluid.