Reseting the ECU?

Trips · 06-05-2013, 07:56 PM

^^^

Thanks for Helping

Quote:

Originally Posted by Zbrah

On my gc I usually just disconnect the negative on the battery and let it sit for few minutes and the ecu resets itself, not too sure if this will work on your Z because I don't own one yet.

Same thing on the Z

Also

Op, Be warned you will probably need to do a window reset also

1. Push the ignition switch to the ON position.

2. Close the door.

3. Open the window completely by operating
the power window switch.

4. Pull the power window switch and hold it to
close the window, and then hold the switch
more than 3 seconds after the window is
closed completely.

5. Release the power window switch. Operate
the window by the automatic function to
confirm the initialization is complete.

6. Perform steps 2 through 5 above for other
windows.

Baer383 · 06-05-2013, 07:58 PM

Quote:

Originally Posted by Triple's

^^^

Thanks for Helping

Same thing on the Z

Also

Op, Be warned you will probably need to do a window reset also

1. Push the ignition switch to the ON position.

2. Close the door.

3. Open the window completely by operating
the power window switch.

4. Pull the power window switch and hold it to
close the window, and then hold the switch
more than 3 seconds after the window is
closed completely.

5. Release the power window switch. Operate
the window by the automatic function to
confirm the initialization is complete.

6. Perform steps 2 through 5 above for other
windows.

Thanks for helping out Trip

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode