|
Did a little work on the ol’ Z this weekend… getting ready for FI… ;^P Had a struggle with the Quaife earlier this week but got it finally going, shims
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
03-03-2013, 10:52 PM
|
#1 (permalink) |
|
Enthusiast Member
 
Join Date: Feb 2012
Location: In the shop
Posts: 281
Drives: Women Crazy
Rep Power: 14  |
Started some Z projects...
Did a little work on the ol’ Z this weekend… getting ready for FI… ;^P
Had a struggle with the Quaife earlier this week but got it finally going, shims will be here Tuesday and that can go back in.  Bought a SouthBend Stage 3 clutch, new lightweight steel flywheel and HD CSC from Zspeedperformance, that should be here next week… Gotta pull the tranny for that to happen.     Cleaned up all the nasty clutch dust, ready for the new ZSpeed HD CSC… that will be nice!  Bought an AEM failsafe dual boost – A/F guage, needed a spot for it, decided to put it on the drivers side A pillar down low similair to Galeforce’s custom one, a little bondo work and some texture paint, should look pretty good.       Also installed my new front Hotchkis sway bar, got to wait for my Quaife to get done before I install the rear.  Didn’t take pics of the Z1 motorsports stainless steel clutch line… didn’t have time! The whole damn bottom of my car is gone!  
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mid-A projects thread | dmhenderson | Mid-Atlantic Region | 27 | 01-30-2013 07:49 PM |
| Holiday projects? | dmhenderson | Mid-Atlantic Region | 62 | 01-03-2013 10:14 AM |
| Starting some projects! | nismochiq | Exterior & Interior | 18 | 11-12-2012 06:22 PM |
| Plasti dip projects | ericzmyers | Exterior & Interior | 7 | 08-18-2012 03:04 PM |
| A Couple Recent CF Projects... | Carbon Fiber Element | Exterior & Interior | 10 | 01-20-2011 08:05 AM |
3Likes
Threaded Mode
