Engine Swap

RekeHavoc

My apologies if this has been answered before. I'm sure it has.

I have a 2009 6MT with the dreaded oil consumption issue. I am considering doing an engine swap.

A 2018 7AT engine will swap into my car, correct? My understanding is that all of the VQs are essentially identical. Can I use my existing ECU, wiring harness and trans? Other than accessories, is there anything else that I would need to swap over?

Thanks!

husam2012

Everything will be identical, you'll need to use the harness, trans and ecu from your car. You'll also need to swap out the auto pilot bushing for the manual pilot bearing. Make sure to remove the auto one or you'll have shifting problems. Everything else is identical.

__________________
Creator of the GTR TT Conversion Kit, NA Record Holder (401WHP)
Ecutek Master Tuner (VQ37, VR30, VR38, B58, S55, S58)
BTWTuning

vtec to vvel

Don't forget about the paddle shifters.

Is there a reason you're going from M6 to A7? It's usually the other way around, and wouldn't it be easier/cheaper just to swap with another M6?

__________________
Don't like what I post? Too bad. I really don't give a sh!t

xxAGAVExx

I believe OP is just changing engine, not trans, and asking questions on engine from an auto fitting in his manual.


Sent from my iPhone using Tapatalk

__________________
l 09/6MT l BP Twin Turbo Kit l E-85 w/Fuel Return l FI 18" Res CF CBE l Powertrix Ultra-Lite Coilovers l Wavetrac LSD | Lots of SPL and Carbon Fiber |

vtec to vvel

Make sense if that's the case.

__________________
Don't like what I post? Too bad. I really don't give a sh!t

filip00

What is the oil consumption issue you're talking about? Asking because I have a 2009 and it doesn't consume any oil. Gallery gaskets were changed.

ihaveashihtzu

Some of them burn oil, I've had 2 cars with the VHR and one of them burns oil and the other one didn't at all. Both were 2011. Seems like it's from excessive blow by cause there's a decent amount of oil in the intake when I removed it to change injectors.

RekeHavoc

Thanks for the confirmation, guys. I am not swapping to the auto trans. I would just be swapping the engine itself.

Mine has always burned a little oil from day one. I didn't think much of it as it wasn't much early on. When I noticed it becoming more excessive, I did some research and discovered that there was a TSB. However, by that time, I was already out of warranty. I wish I would have known before, but of course Nissan didn't exactly advertise it.

There is a huge thread on here about the issue. My understanding is that it is caused by the valve seals and piston rings.

I could be wrong but the gallery gasket issue usually presents as a low oil pressure situation not consumption, correct? I have never changed those.

Car has 170K on the clock and still runs great. I just have to keep topping up the oil routinely.

Jhill

That’s a bummer, I hate oil consumption issues after owning a car that would consume oil (VW, what a surprise I know) it’s not fun or cheap is using good oil. So far I’m about 156k and still don’t use any oil it just been such a good car. If it’s just your valve stem seals that may be a cheaper route if you find a shop that can do it without removing the heads (using compressed air).