Nissan 370Z Forum  

No Spark!! aahhh

I just installed new timing chains,gear, cylinder heads, camshafts JWT C2 headers.I have the car all put together. I tried to start the car nothing, fuel pump cycles and put

Go Back   Nissan 370Z Forum > Nissan 370Z Tech Area > Engine & Drivetrain


Like Tree3Likes
  • 1 Post By SteveSAS
  • 1 Post By scroupious
  • 1 Post By INFmstrTech

Reply
 
LinkBack Thread Tools Display Modes
Old 04-04-2020, 05:25 PM   #1 (permalink)
Base Member
 
Join Date: Aug 2019
Location: IOWA
Posts: 27
Drives: 2009 370Z
Rep Power: 6
scroupious is on a distinguished road
Default No Spark!! aahhh

I just installed new timing chains,gear, cylinder heads, camshafts JWT C2
headers.I have the car all put together. I tried to start the car nothing, fuel pump cycles and put out 45psi but no spark. put timing light on the wire the nissan manual tells you to check nothing. Pulled a coil and plug and ground that out still not spark. Checked all my grounds seem good. Where do I begin checking?

Thank you for your advise greatly appreciated. Once she starts it is off to get tuned
scroupious is offline   Reply With Quote
Old 04-05-2020, 08:08 AM   #2 (permalink)
Base Member
 
Join Date: Jun 2018
Location: Australia
Posts: 61
Drives: 370z
Rep Power: 5364
SteveSAS has a reputation beyond reputeSteveSAS has a reputation beyond reputeSteveSAS has a reputation beyond reputeSteveSAS has a reputation beyond reputeSteveSAS has a reputation beyond reputeSteveSAS has a reputation beyond reputeSteveSAS has a reputation beyond reputeSteveSAS has a reputation beyond reputeSteveSAS has a reputation beyond reputeSteveSAS has a reputation beyond reputeSteveSAS has a reputation beyond repute
Default

You maybe out of timing a bit. Did you turn engine over a few times manually before push button start? Make sure your not way off.

See P0340

Doesn't take much before it doesn't let you start.
scroupious likes this.
SteveSAS is offline   Reply With Quote
Old 04-05-2020, 09:59 AM   #3 (permalink)
Base Member
 
Join Date: Aug 2019
Location: IOWA
Posts: 27
Drives: 2009 370Z
Rep Power: 6
scroupious is on a distinguished road
Default

Quote:
Originally Posted by SteveSAS View Post
You maybe out of timing a bit. Did you turn engine over a few times manually before push button start? Make sure your not way off.

See P0340

Doesn't take much before it doesn't let you start.
SteveSAS-Thank you for your reply. NO I did not it sounds like I need to check that. I appreciate the advise. I am a Noob to the 370Z so used to old school cars hahah.

Thanks again!! i will check it
scroupious is offline   Reply With Quote
Old 04-05-2020, 08:42 PM   #4 (permalink)
Base Member
 
Join Date: Aug 2019
Location: IOWA
Posts: 27
Drives: 2009 370Z
Rep Power: 6
scroupious is on a distinguished road
Default

Quote:
Originally Posted by SteveSAS View Post
You maybe out of timing a bit. Did you turn engine over a few times manually before push button start? Make sure your not way off.

See P0340

Doesn't take much before it doesn't let you start.

Follow up. Well Timing was still perfect. After rotating the engine for about 2 hours i discovered that i put the Intake camshaft sprocket on the wrong sides!!!
OMG ugh.

Once again thank you for the advice
JARblue likes this.
scroupious is offline   Reply With Quote
Old 04-10-2020, 09:30 PM   #5 (permalink)
Base Member
 
INFmstrTech's Avatar
 
Join Date: Nov 2018
Location: Near Frisco, TX
Posts: 42
Drives: 08coupe, 07sedan
Rep Power: 6743
INFmstrTech has a reputation beyond reputeINFmstrTech has a reputation beyond reputeINFmstrTech has a reputation beyond reputeINFmstrTech has a reputation beyond reputeINFmstrTech has a reputation beyond reputeINFmstrTech has a reputation beyond reputeINFmstrTech has a reputation beyond reputeINFmstrTech has a reputation beyond reputeINFmstrTech has a reputation beyond reputeINFmstrTech has a reputation beyond reputeINFmstrTech has a reputation beyond repute
Default

Quote:
Originally Posted by scroupious View Post
Follow up. Well Timing was still perfect. After rotating the engine for about 2 hours i discovered that i put the Intake camshaft sprocket on the wrong sides!!!
OMG ugh.

Once again thank you for the advice
Just for future reference the sprockets are labeled L and R respectively
Attached Images
File Type: jpg 5FBC45A0-3523-4381-8129-4F36849F1B49.jpg (255.2 KB, 10 views)
Rusty likes this.
__________________
‘08 coupe w/Stillen SC, Custom A2A, SD, ID1050x, e85, eagle rods, high temp coated pistons, P&P heads, JWT C2, manual swap, stage 2 clutch. EcuTek(Eugene)
INFmstrTech is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Spark Plugs ihiryu Forced Induction 17 05-02-2018 10:32 AM
[FOR SALE] NGK GTR Spark Plugs Lt8Che Parts for sale (Private Classifieds) 7 02-14-2017 08:26 PM
spark plugs Jimbo370 Engine & Drivetrain 1 12-19-2016 06:30 PM
spark plugs Jimbo370 Engine & Drivetrain 5 12-04-2016 10:22 PM
Gtr spark plugs for the z tiller Tuning 2 11-18-2015 02:29 PM


All times are GMT -5. The time now is 03:40 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2