08-27-2018, 07:48 PM
|
#7 (permalink)
|
|
Base Member
Join Date: Mar 2012
Location: Orlando
Posts: 45
Drives: 370z TS M6
Rep Power: 14
|
Quote:
Originally Posted by SG4247
Both sides are not threaded.
The early 370 had threads in the drive axle hole and a through hole in the side flange. Bolts are installed from the pumpkin side, which is a PITA. This was reversed in later models, where the side flanges were threaded and the through holes where in the axles. I belive this change was made to improve tooling and reduce assembly cost at the vehicle assembly plant.
|
The pic you posted is the original setup on mine (2009). With the swap of the 2017 pumpkin on first install I had threads on the short shafts (original) and threads on the output shafts (new). This obviously wouldn't work as I couldn't torque down the bolts with double threading. So I had to swap the output shafts.
|
|
|
Similar Threads
4Likes
Threaded Mode
