![]() |
Has anyone attempted to replace the rear trunk light? I just swapped out the map lights with blue and also added blue license plate bulbs....got a few spare blue LED's
|
![]() |
|
LinkBack | Thread Tools | Display Modes |
![]() |
#1 (permalink) |
RIP Tony :( (1969-2015)
![]() Join Date: Feb 2009
Location: Northern Virginia
Posts: 18,802
Drives: '14 Mustang GT/CS
Rep Power: 67 ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
![]()
Has anyone attempted to replace the rear trunk light? I just swapped out the map lights with blue and also added blue license plate bulbs....got a few spare blue LED's left and figured I'd replace the trunk light.
I popped it off and pulled it free of the wire housing and it looks like it has a tiny fuse and some type of copperish cover somewhat over the bulb. I tried to jiggle it free but no luck. I tried to take pictures but my camera sucks. Any suggestions or ideas? It pops off with just a little pressure with 2 flathead screwdrivers on the sides of the casing. Thats how I did it.....you could probably use just 1 screwdriver and slide it around the casing.
__________________
![]() SpinTech Mufflers, Airaid CAI, JBA H-Pipe, Lethal Performance Over Axle Pipes, MMD Quarter Panel Louvers, Cervini's Ram Air Type IV Hood, Carbon Fiber Radiator Cover, GT500 Rear Valance, Quad Exhaust Tips
|
![]() |
![]() |
![]() |
#3 (permalink) |
Track Member
Join Date: Jun 2009
Location: SoCal
Posts: 821
Drives: Graphite Bullet
Rep Power: 369 ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
![]()
I have a few White LED's left as well and was about to do this.
At least now I know how to pop off the lens ![]() ![]() DIGItonium, what did you do to "custom retrofit" your trunk light LED?
__________________
![]() 2009 PG 6MT Sports Stillen Gen3 CAI | Stillen CBE | AMS Short Shifter | Nismo Brace Kit |
![]() |
![]() |
![]() |
#4 (permalink) |
A True Z Fanatic
Join Date: Jan 2009
Location: Kansas
Posts: 3,800
Drives: 09 Z34-TT 6MT
Rep Power: 43 ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
![]()
In the 350Z, I created an 18 LED array on a PCB and squeezed the board in. For the 370Z, I mounted a small heatsink to the Luxeon K2 Star and some resistors. Then soldered directly to the bulb socket.
__________________
![]() |
![]() |
![]() |
![]() |
#5 (permalink) | |
RIP Tony :( (1969-2015)
![]() Join Date: Feb 2009
Location: Northern Virginia
Posts: 18,802
Drives: '14 Mustang GT/CS
Rep Power: 67 ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
![]() Quote:
![]() ![]() Check my Yellow & Blue gallery thread....I uploaded pics of the blue LED map lights and blue license plate lights. ![]()
__________________
![]() SpinTech Mufflers, Airaid CAI, JBA H-Pipe, Lethal Performance Over Axle Pipes, MMD Quarter Panel Louvers, Cervini's Ram Air Type IV Hood, Carbon Fiber Radiator Cover, GT500 Rear Valance, Quad Exhaust Tips
|
|
![]() |
![]() |
![]() |
#7 (permalink) |
A True Z Fanatic
Join Date: Jan 2009
Location: Kansas
Posts: 3,800
Drives: 09 Z34-TT 6MT
Rep Power: 43 ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
![]()
Whoa dude... that's hella blue! Haha. The most recent LED mod for me was the amber courtesy LED in the map light assembly. It is a fairly painless mod, once you open up the small module with the LED inside. It doesn't require any solder work as the LED, diode, and resistor are wedged into blade connectors.
It stinks I'm not able to pull off the knobs of the HVAC controls to pull the PCB to change out the LEDs... I'm going to need help from anyone who plans to mod the HVAC LED color.
__________________
![]() |
![]() |
![]() |
![]() |
#8 (permalink) |
RIP Tony :( (1969-2015)
![]() Join Date: Feb 2009
Location: Northern Virginia
Posts: 18,802
Drives: '14 Mustang GT/CS
Rep Power: 67 ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
![]()
I can see it already......modding my lights are my new obsession!!
![]() Short vid of how things look @ night......nevermind the end with the moths....I killed 'em after I shut the camera off! ![]() It is pretty darn blue, isn't it? But I like it! ![]()
__________________
![]() SpinTech Mufflers, Airaid CAI, JBA H-Pipe, Lethal Performance Over Axle Pipes, MMD Quarter Panel Louvers, Cervini's Ram Air Type IV Hood, Carbon Fiber Radiator Cover, GT500 Rear Valance, Quad Exhaust Tips
|
![]() |
![]() |
![]() |
#9 (permalink) |
Car Audio Installer
![]() |
![]()
I like the inside lights not a fan of them outside. Nice look.
__________________
Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/ |
![]() |
![]() |
![]() |
#10 (permalink) |
Track Member
Join Date: Jun 2009
Location: SoCal
Posts: 821
Drives: Graphite Bullet
Rep Power: 369 ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
![]()
The trunk light was very easy to replace. The housing can be removed with a thin flathead or your finger nails.
Remove the power source so replacing the bulb is easier with the housing free of cords and such. Remove the little plastic clip piece then simply pull out the bulb. Replace with LED 194 type (got mine from VLEDS) and reconnect to power source to verify if it works. If the LED is not lighting up simply reverse the polarity then re-install the plastic clip. Reconnect to power source and put housing back in place.
__________________
![]() 2009 PG 6MT Sports Stillen Gen3 CAI | Stillen CBE | AMS Short Shifter | Nismo Brace Kit |
![]() |
![]() |
![]() |
#11 (permalink) |
RIP Tony :( (1969-2015)
![]() Join Date: Feb 2009
Location: Northern Virginia
Posts: 18,802
Drives: '14 Mustang GT/CS
Rep Power: 67 ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
![]()
Got the bulb in today! Woo hoo!
![]() ![]()
__________________
![]() SpinTech Mufflers, Airaid CAI, JBA H-Pipe, Lethal Performance Over Axle Pipes, MMD Quarter Panel Louvers, Cervini's Ram Air Type IV Hood, Carbon Fiber Radiator Cover, GT500 Rear Valance, Quad Exhaust Tips
|
![]() |
![]() |
![]() |
#12 (permalink) |
Base Member
Join Date: Jul 2009
Location: San Diego
Posts: 50
Drives: 370z base 6 sp
Rep Power: 16 ![]() |
![]()
do u have blue LED on the plate as well??? i thought it's illegal....
anyways, so how many bulbs are there?? two for the map one for the trunk two for the license plate? i'm about to order my bulbs~~ |
![]() |
![]() |
![]() |
#13 (permalink) |
Track Member
Join Date: Jun 2009
Location: SoCal
Posts: 821
Drives: Graphite Bullet
Rep Power: 369 ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
![]()
Yes.
2 for the map lights 194 type bulbs 2 for the license plate 194 type bulbs 1 for the trunk 194 type bulbs
__________________
![]() 2009 PG 6MT Sports Stillen Gen3 CAI | Stillen CBE | AMS Short Shifter | Nismo Brace Kit |
![]() |
![]() |
![]() |
#15 (permalink) |
A True Z Fanatic
Join Date: Aug 2009
Location: Chicago Burbs
Posts: 1,439
Drives: 09 370z Supercharged
Rep Power: 44 ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
![]()
if anyone is looking to do this, order the "flank" style bulbs from v-leds. they have 6 leds that face to one side which is perfect for that housing.
|
![]() |
![]() |
![]() |
Bookmarks |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Local 370z needed for smoked tail light and head light fitting | dantegts | Southern California Region | 11 | 04-07-2010 08:55 PM |
smoked tail light and head light volunteer covina, ca area | dantegts | Exterior & Interior | 0 | 08-29-2009 01:33 PM |
Tire Replacement warning light | ddvette9 | Nissan 370Z General Discussions | 6 | 06-23-2009 07:59 PM |
Interior Map light ( replacement bulbs ) | 355890 | Exterior & Interior | 26 | 04-23-2009 06:27 PM |
Euro fog light (aka b__hole) replacement ideas ! | travisjb | Exterior & Interior | 21 | 03-04-2009 10:22 AM |