![]() |
Ok pic attached, its not the greatest angle but there definitely is no plug anywhere near the OBD port.
http://i48.photobucket.com/albums/f2...3/image1-3.jpg |
Mine and most people found this female 1 wire plug,if you run your hand slowly up the wiring harness (from the OBD2 port) you should feel a bump in the harness you will have to cut the tape back and expose it.
|
Quote:
|
is there a way to just make it turn off? like pull a fuse or something... when i swapped wheels... my tpms went with it... so i check my pressure every so often.... but that light irritates me to hell lol
|
Has anyone been able to track down the reset plug on 2012s yet? I have a 2011 and could not find the one mentioned in the service manuals. I even checked the BCS section of the manual didn't see a wire coming out of connector M123 pin 149 from the BCS. I would love to kill that flashing light!!!
|
imma give this a shot this weekend :D
|
Awesome info! Thank you for sharing!
|
Quote:
So did it work for you brotha? |
Quote:
|
1 Attachment(s)
Quote:
Well?!!?? Attachment 78975 :roflpuke2: |
1 Attachment(s)
Mine is an 09 model, i just went look and i'm not sure where to put the paperclip.
This is what i can see. Attachment 78976 |
Quote:
|
I'll try it today if I can figure out where to put to paperclip. Can you tell by looking at my pic?
|
i think its hidden further up the line i believe... it should look like on plug with one wire connected from what i read
|
So to be clear Front LH means drivers side front tire and Rear LH means drivers side rear tire, correct?
|
All times are GMT -5. The time now is 01:25 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2