09-20-2022, 01:26 PM
|
#16 (permalink)
|
Base Member
Join Date: Feb 2021
Location: california
Posts: 32
Drives: 370z MR M6
Rep Power: 196
|
Quote:
Originally Posted by Brendan
20mm spacer out back and those wheels and tires wont need a fender roll. you will hit the fender tab before that happens. Tire size will be good too. just don't run too low. I was around 26.5" from ground to fender as nissan tells you to measure, running 275/40r18. now I am on 315/30r18 but I had to raise the car a little keep the 315 off the fender tab under heavy loads and bumps so its 26.75" now with the shorter but wider tires.
Heres the 315 with the car a little higher than I needed because I wanted to be sure they cleared. It was 27" in this photo _BES6507 by brendan sobers, on Flickr
and here is an older photo on the 275. I could get much lower since the tires were more narrow. same camber with both setups. -3.5~
_BES6734 by brendan sobers, on Flickr
|
Hiya mate. I'm curious why you decided to run a 40 section tire instead of a 35 with the 18 inch wheel?
My setup is street car biased with track attitude. Camber is -1.8, caster ended up at 6, I was running 0 Toe but I think this might have been too aggressive so I toed in a bit. I'd like to run 285 35 18 square for track use here at Laguna Seca, Sonoma, and Thunderhill. Just curious what offsets would work. +15 rear and +25 front? Maybe more?
I read on the linked wheel fitment guide that 18x10.5 or 18x11 wheels, +15 to +20 offset and some 275 or 285's all around seems to work. Not sure how much camber that is though
Last edited by Iammeowwwwww; 09-20-2022 at 01:47 PM.
|
|
|