Will wheels fit?
 

I know there is a sticky on this but I've read thru it over and over but was unable to find enough info. I'm looking at forgestar f14. Stamping on the inside of the wheel says 19x9 and 19x10. Believe the stamp reads the offset is 26 on the 19x9 and 13 on the 19x10 running 255/40 and 285/35. I do have sport brakes too n my Z as well. Thanks for any help!

Uncertain; but the guy's at Getyourwheels.com will know.
The +26 9's would have to be semi-deep@+26 & SDC +13 19x10's...that's the only way those 2 particular sizes are made.
That could be information for someone else to know & could answer.

The fronts would be just a tiny bit aggressive, it may fit perfect. Kinda depends on each wheel. But with them being F14's, I'd say they will fit without issue

Appreciate the replies! Was Hoping there would be no fitmit issue. He's asking 800 w/ continental tires. Wanting them to look pretty square.

If there is no interference w/brakes; they will sit good.

As jchammond said, contact getyourwheels. Jason will tell you for sure if they clear sport brakes..

Ok! I'll get ahold of Jason. Appreciate all the input

Are you on stock suspension or lowered?

The outer wheel lips will sit 1mm further in than mine. Front & Rear...the top will probably lean in a tad more in rear; as in this pic I'm at nearly 0* camber out back.https://uploads.tapatalk-cdn.com/201...7f3dde4f22.jpg


Sent from my iPhone using Tapatalk

Yea I am at stock height for now. Have debated on lowering but the roads around here are horrible as it is and already have clearance issues. Your setup looks great! Guess the offset would be to my liking

19x9 +26 would be semi aggressive? Stock nismo wheels are 9.5" +40 front, thats pretty much the same within a few mm. Nismos sit plenty within the wheel well too.

or did I read your post wrong? Thats possible.

It's not aggressive at all, certain people throwing term around way too loosely.

Folks run 19x9.5 +22 te37 sizing all the time with mild suspension setups (stock or shock/spring)

More proof:
OEM Nismo is 19x9.5 +40 front
A 19x9 +26 only extends 8mm out more. Thats . . . nothing.

If you have SPL front upper control arms your fitment options are basically limited only to the skill of your alignment guy.

i have 20x11 +15 in front with a 275/30, on OEM metal. I don't really wanna here anyone talk about how 19x9 +26 is aggressive. Its not even a finger's width past stock.

Everyone with a wheel question should read THIS POST: http://www.the370z.com/wheels-tires/...tml#post809487
It's from the Wheel Fitment Guide thread

19x9.5 +22; 19x10.5 +12
265/35/19; 305/30/19
KW v3, height set with fender clearly above top of tire (about 1 finger gap)

I do not consider that aggressive. To me, thats "normal" - perfectly fine for all forms of driving and better than stock
Near stock would be considered "stupid"
my setup would be "aggressive"
widebody + bags would be "super aggressive"

And there's gradations between

Jason was right on it. Thanks for the advice everyone. Stated they will clear the akebons no problem.

It's wheel specific. I run 19*10 +30 up front on Swift's. My fitment is flush. With 285's, it rubbed the liner in one spot just a tiny bit. A +26 with my wheels would be poking. But I don't run an 11" wheel with 275 tire.

To put it into perspective, every half inch is 12.7mm. my wheels at +30 stick out 9mm further than the OP's specs.

Zero's fitment is over an inch past the body, which implies he's running a stretched tire, with a low profile, and added some camber to fit them.

It depends on how you want it to fit. But based on the specs, your more than okay

Jason is the bomb.