![]() |
Quote:
|
It's not always this bad they open up some in the fall
|
Might make the 30th or 31st of this month at HighPlanes. Anyone else?
|
Hello,
I drove up from Lincoln, NE to vacation here with my family and i've been looking for some good driving roads near estes park, I drove on Colorado highway 7 from estes to allenspark today and that seemed like a pretty good direction. I obviously plan to drive over the continental divide and do devils gultch (steep switchbacks between estes and glenhaven). I was just curious if the Denver area guys had any recommendations in the area. I'm excited to do some driving cause normally we go 4x4'ing here in this area but not really looking for great paved roads. Thanks guys! KBC |
Quote:
I signed up for one a couple of weeks ago, but since it was the 4th it was cancelled. Hope that helps! |
Rims and tires.
Hey Denver Z owners. I have a set of base 18" 370z rims with Yokohama tires for sale. They are in excellent condition with only about 3000miles and no curbing, etc. Would make a great set of winter wheels! Will let go for $800 and meet you half way for pickup. i will post pictures.
http://www.the370z.com/members/zrace...rims-sale.html |
Quote:
The road up to wild bills grave from golden is great also the road up to kitridge park from red rocks is pretty nice. |
In Colorado at what point will I fail emissions:
1 - Fast Intentions RHFC + resonated CBE + Uprev tune 2 - Fast Intentions Long Tube Headers + resonated CBE + Uprev tune 3 - Fast Intentions Test Pipes + resonated CBE + Stillen Supercharger + Uprev tune 4 - Fast Intentions Long Tube Headers + resonated CBE + Stillen Supercharger + Uprev tune Is this question unanswerable? (Please let the answer be 2 and above). |
Quote:
|
Quote:
You should look into ecutek for a tuning option! I just sent my first log to Sebastian at Specialty Z, I will let you know what I think of it when I am finished! |
Quote:
|
Quote:
|
Quote:
I passed Emisions (Jeffco) with Berk HFCs installed. I'm hoping to pass this year with my test pipes using the "drive by" onramp sensors but we'll see. (Maybe I can idle by the test van). |
Quote:
|
Quote:
Since you said Colorado, I think Denver area is the only one still doing exhaust checks. I know El Paso county doesn't. |
Quote:
|
in Denver and Jeffco they run you up a dyno for exhaust gasses, check your o2 sensors via OBD2 port and check your gas system with the little gas cap suction thingie (or is it pressure).
However if you drive by the on ramp truck with the sensors out next to them three times with low enough visible emissions (as seen by the sensors by the truck) you will not need to get an inspection. (I think you have to pass the first year to get registered with a plate but can pass the trucks after that first registration year because the truck scans your plate when you zip by...hopefully with your foot off the gas) |
My twin FI setup passed with no issues. Cobb tune, injectors, exhaust the whole deal. That is once they figured out how to get my Z to hold revs on their machine. ;-) Nothing wrong with the car, just went through a couple rookies scared to break it.
|
Quote:
|
Anyone here with an oil cooler have an oil pressure gauge installed? I want the Stillen Oil cooler but would like to know my pressure... Thanks :tiphat:
|
I'm going to the evening session open track day at High plains raceway this Thursday (3 September)
I've had zero luck on this forum getting guys to come with, but I'll put it out there again. It will be: me in the Z Bill in his 1970 Ferrari Daytona (very fun car to track) Jerry in his 65 comp corvette (completely race car converted and SWEEEEET) I think the drivers meeting starts at 1530 (3:30) 100 bucks and a helmet is all you need (well a car helps too) Stock setup is fine and bill who is a pretty good driver and I would be happy to show you the ropes. Ive never seen anybody hurt a stock car out there (drive to your comfort...its NOT A RACE) you will likely: 1.use up a bit of outside tread on your left front tire. 2.burn up a little bit of your brake pads. 3.have a BLAST! After the track day I go back up to conifer and swap out my pads (for streets) in the garage. Pick up some pads and I'd be happy to pop yours in (or show you how) too. A lot of guys are pretty happy with OEM pads so if thats all you can find bring them allong and well put them in at the end of the day. Also its a good idea to bleed your brakes before hand (take out the DOT3 for sure and put in DOT 4.) you need two people but if your already jacked up doing your pads its a 5 minute job. ...Or just come out and ride with Bill, Jerry and Me in the passenger seat. you will still have a blast and if you've never tracked you'll learn ton! (just bring a Helmet If you've got it so you don't have to rent one) |
Made it to High Planes today. Just drove the morning session. A blast that was. Woot for limp mode. Time for an oil cooler.
|
Pass through
Quote:
I have stock headers HFC and stock resonators and a larger Y-Pipe with no mufflers. My method was to gain speed at the beginning of the on ramp and cruise through in neutral from about 150 feet away from the ramp truck. I received my registration renewal in the mail with no request for emissions. Keep your HFC and keep :driving: |
Quote:
|
|
I got to lap with and ride on a lot of cool cars.
Mclairen Porsche 911 turnoS 69 Ford GT-40 70 Farrari Daytona GTR C5 Vette 240 full race Z Austin Martin vantage The list goes on. You guys really need to take me up on these track days. They are great! |
1 Attachment(s)
|
|
Just picked up a Z!!!
Been in Denver my whole life and finally picked up a Z hopefully this gets checked, car culture is strong here so I can only imagine it will be!
|
Hey Denver dudes, I know its last minute but tomorrow Oct 24th, Adam's Polishes is doing a free car care clinic at 10am. its at their store in Louisville, I'm also told they'll let ya play with some of their toys and doing a raffle and a giveaway.
|
I've been out of the Denver area for awhile, but I sold my car down there and have my Saclam exhaust for sale there. PM me with any questions if anyone is interested. For sale forum link is below. Thanks
http://www.the370z.com/parts-sale-pr...ml#post3344626 |
I tracked the z last Friday and am going again this Friday (high plains raceway out near Byers.)
Anybody want to come out and join?? |
It seemed like the Denver thread is dead
|
Thread is a bit dead, but the people are still here.
|
Quote:
|
Quote:
|
Quote:
|
This at HPR last Tuesday.
The Z is a pretty good film chase car as ith fast smooth and not too loud to hear my buddy's cars. https://www.youtube.com/watch?v=qDjkSUbTmnw |
Quote:
|
New Z
New Z Owner In The 303 Area! Hope To see Some Of You Guys !
|
All times are GMT -5. The time now is 06:11 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2