Ill let you know of and when I install them. But I won't let you know what happen so that you can learn off my mistakes!!! Bwahahahahahha!! Unless your giving me a tip. Deal?

Sent from my SPH-L710 using Tapatalk 2








Just kidding

Lol Damn I thought you were nice haha

Bwahahahahaha (evil laugh)

Sent from my SPH-L710 using Tapatalk 2

Just fitted F.I Rtp and they are awsome , done 2k on them and no cel .
Just remember that when u fit test pipes that u will get a hiss when the revs drop below 2k.
Other than that , F***ing AWSOME .
Did the instal myself and took me 1hr 20mins :happydance:

Do you have a video of it? How much did your run for?

Sent from my SPH-L710 using Tapatalk 2

How did you Remove the demon bolt? That's very fast

The best way is that u have the correct tools to do the job , use an 30" extention 3/8 for the bolts that face into the engine bay , i used the gear wrench for the bottom ones the gearwrench had a piviot on the ring end .
Had driven the car then jacked it up to get it nice and warm and they fell off no problems .
Its a pitty that ur not in So Cal would help u out .
If u need help u can call me just pm ur number and would call u .
Also when it came to the O2 sensors be very very gentle , i stripped the threads on the sensor and had to buy a die to cut the threads .
:rolleyes:

Is there a DIY video for this?

Sent from my SPH-L710 using Tapatalk 2

You don't need a vid , the instructions from tony from F.I are all u need .
I did it in a good time due to wrenching on cars since I was 10 and driving at the sametime .
All u need is good sockets and extension .
All the nuts and bolts are 14mm . U need to remove the bracket for the cats .
The cats u unbolt the 2 bolts from under the car then get the last one from the engine bay ..........
I think I should make a vid or take some picks this weekend .:pics:

Make a video and it'll prolly be stickied as a DIY. I can't find a good step by step video of how to do the complete installation with sensors and stuff.

Sent from my SPH-L710 using Tapatalk 2

Ok guys I got FI cbe stillen g3 and have a set of FI res test pipes on the shelf, do I need a tune if I install test pipes? People have told me yes, is this true?

I ran them with 0 issues Will!
Just install them dammit!!! You'll thank me later!!!

Talking with tony from F.I u do not need a tune .
It is an option if u want more hp but I have been monitoring the air to fuel ration on my car and its not gone lean . Sum might say different bit it's up to u :ugh2:

I agree him :iagree::icon18:

lol ok, But what mods do you have? Are you running the same setup as me? intake, CBE and TP?

And Andrew I know right lmao...:roflpuke2: