Dyno Runs- Maps from Motion Lab

ANMVQ

Just made an APT to have some runs done on Saturday @ 9am, Dynotechtuning.
Going to make 6 runs 3 runs on my REV2 and 3 Runs on my REV3 maps from Motion Lab. Still not on my end tune but close.

Any guesses what I'll make ?
Again the below review is only of dynotechtuning and not Motion Lab which is a A++ company and Alex a Todd are SUPER. Just 13 hrs from me one way
.

__________________
14 Q50 AWD, ARK, ECUTEK (SEB), Takda,

bleunetizen

would be great if you can post up some logs showing ignition timing / VVEL etc

Legz

Thought your engine was just pinging, now you're going to the dyno? lol

__________________
GTM TT G37x coupe! Stage2 8.5psi Hotchkis | GTSpec | Eibach | PLX | Exoticspeed

ANMVQ

It "did" I reset the light had everything looked at was told the misfire would cause the cam timing to jump, Coils and plugs are all good, oil is clean and full, Just may have been bad gas. I have been beating the car a little the past few days to make sure it doesn't come back,


I will have logs up also,

__________________
14 Q50 AWD, ARK, ECUTEK (SEB), Takda,

ANMVQ

Just left for the dyno, Dynotechtuning

__________________
14 Q50 AWD, ARK, ECUTEK (SEB), Takda,

7speed

Nice. Hopefully no issues.

__________________
09 370z 6spd traded 1/12/15 for 15 Challenger RT 6spd

ANMVQ

Just got here early as usual cars cooling off . Just me here so far .
Hope so checked everything again yesterday

__________________
14 Q50 AWD, ARK, ECUTEK (SEB), Takda,

ANMVQ

Ok so we all know first impressions are almost everything ,
The doors open and some guy is looked at me and walked away then picked up his cell and started talking to someone on the phone I walked past him twice stood in front of him and didn't say hi or anything like I wasn't there . Then turned around and went inside ? Another guy just pulled up in a STI got out and at least said hi :/

Strapping it done now.

__________________
14 Q50 AWD, ARK, ECUTEK (SEB), Takda,

ANMVQ

Ok 2 runs each map , I'll give the short over view.
Dyno READS LOW! Tuner made me nevous ( don't know what a Ford Focus ST) asked if was like a Honda ? Then after the second pull my :/ AWD light was flashing at the top of each run( last run I cut short as I was in the car logging ) and not sure he would have even said anything as after I told him it was flashing he seems surprised ? Um aren't you supposed to watch those things ?
So final numbers were 260 WHP and 240 WHTRQ ( ok he said they dyno reads 15% lower than anyone else as he doesn't use the numbers for tuning there just numbers he said . )
So I don't know what to say I got done what I needed done my logs but seriously one pull was cut short by me @6500 cause the light stared blinking again and the numbers are BS .
I don't want to see inflated numbers but at least show the real ones.
He has never touched a G or Z car and could tell that for sure . He was tryin to make te first pull in DS MODE :/ . Will never visit this place again !! I mean seriously a STOCK car puts down more than I did :/ . guess I should have waiting till oct you use my regular dyno.

The numbers would work out @15% to be 299 WHP 276 TQ numbers are would be to high. I'll post the sheets after I finish washing the cars

Last one is an overlay of the 2 and 4 Runs,

Attached Images

	Dyno Run 2( REV 2 Map).jpg (201.9 KB, 45 views)
	Dyno Run 4 ( REV 3 Map).jpg (191.6 KB, 23 views)
	Over lay of Run 2 ( REV2 Map) VS Run 4 (REV3 Map).jpg (216.2 KB, 37 views)

__________________
14 Q50 AWD, ARK, ECUTEK (SEB), Takda,

mag_black

Should've checked out Granite State Dyno in Hudson, NH.

__________________

FireDan50

This thread had me confused because the title contained "Motion Lab" but the activities were done at another place. I was thinking the thread was about Motion Lab and read how the service was bad and how they never worked on a Z or G and was like "huh?". Might want to change the title to contain "Dynotech Tuning" instead of Motion Lab. I understand now that you had your car tuned at Motion Lab but all the negative posts and even the dyno charts posted are from Dynotech. Its very misleading with the title and might give a good company bad press where it isn't deserved. Sorry you had such a bad experience with Dynotech though....too bad you don't live closer to NC to go back to MLT.

__________________
VSR Single-turbo kit: 611hp/517tq @ 10psi (Q16 race gas)
Dan's VSR top-mount turbo 370z

bleunetizen

is your VVEL tuned ?

ANMVQ

Never called me back , emailed them:/

I can change the topic but it does state maps from Motion Lab
Not @ Motion Lab sorry for confusion
Yes the VVEL is tuned see the Tq spike early ! The numbers are for sure BS I have run my wife a few times in her Q50 and ripped away both times

__________________
14 Q50 AWD, ARK, ECUTEK (SEB), Takda,

bleunetizen

Just realised that, yours seem to have massive torque under 4krpm.

do you have uprev logs of your runs that show VVEL timing?

ANMVQ

Some other things I did talk about over the weekend( was hard to use my phone). Just to elaborate on the the ST thing. A guy called about getting a tune and the tuner was on the phone in front of me, " Yea I haven't tuned one yet but tuning it's all the same, What is that a Mustang? Oh a Focus, Yea I can look around on line and see what that is an I can tune it for sure!" Really tuning is the same for every car ? YIKES! Maybe the EVO and Subi Guys like this place but I was so nervous , when I heard that was like "man glad he's not tuning my car". Then at the end after the AWD light blinking episode he as explaining tuning to me and how Etunes are not good and he had some people asking him to tune Nissan and was going to buy UPREV and start tuning. He wanted me to get in a group thing were we'd prepay and he then would tune the group. No thanx, I Definitily trust Motion Lab, and If I had any faith in anyone local would have went there . The more I think about it I really can believe how bad it was, he didn't even know what engine was in the car asked 3.5 or 3.6 ? Then I'm sure he did set it for a AWD car. I have done at least 6-8 runs up to 125-130 in 4th to get logs prior to this and never had an issue with the AWD light. Just glad it didn't break, But again if I wasn't in the car bet it would have cause he never saw the light blinking nor did he mention maybe we should run it or Gess let me check and make sure I set the dyno to AWD, and the dyno run he tried to make in DS mode!! Nightmare place I will never visit again.

__________________
14 Q50 AWD, ARK, ECUTEK (SEB), Takda,