|
Go job going to SG ! unfortunatly they are closing which is where I always went for all of my Dyno time seat ! hehe I did a baseline on
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
11-03-2011, 08:21 AM
|
#21 (permalink) |
|
A True Z Fanatic
Join Date: Oct 2009
Location: Canada
Posts: 1,156
Drives: 370z
Rep Power: 24   |
Go job going to SG ! unfortunatly they are closing which is where I always went for all of my Dyno time seat ! hehe
I did a baseline on that Dyno with my 2009 7AT and the result was 258 whp the last time I went there fully modded (with bad timing problem probably due to my badly cracked flywheel) more datalog this weekend since I just got the car back from Nissan (replaced the whole AT tranny and flywheel) I had 311 whp with a full bolt-on exhaust I had 280whp so your 303 whp is good with the setup you have 
Last edited by Megan370z; 11-03-2011 at 09:01 AM. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Berk HFC dyno results | Red370 | Intake/Exhaust | 36 | 09-24-2013 03:00 PM |
| My Z's Dyno Results | pty370z | Tuning | 10 | 07-21-2011 02:37 PM |
| K&n dyno results | nismo 1234 | Intake/Exhaust | 26 | 12-02-2010 11:44 PM |
| Dyno Results | TonyBPD | Engine & Drivetrain | 39 | 03-24-2010 04:09 AM |
| *NEW* Dyno results are in.... | 2theextreme | Nissan 370Z General Discussions | 56 | 08-22-2009 08:08 PM |
Threaded Mode
