![]() |
I was reading up on this in the Uprev manual, and it sounds like the ETC table is important for determining line pressure for shifts under load. If so, what
|
Notices |
|
LinkBack
![]() |
Thread Tools
![]() |
Display Modes
![]() |
|
![]() |
#11 (permalink) |
A True Z Fanatic
Join Date: May 2010
Location: nirvana
Posts: 6,394
Drives: 2023 NATM
Rep Power: 418 ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
![]()
I was reading up on this in the Uprev manual, and it sounds like the ETC table is important for determining line pressure for shifts under load. If so, what if line pressure was just bumped up across the board and ETC was off?
__________________
Enjoy it. Destroy it. |
![]() |
![]() |
Bookmarks |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
370Z FI Throttle Response: Boost vs. Throttle Position | DIGItonium | Forced Induction | 9 | 01-23-2011 08:49 PM |
Adjusting Throttle Response with UpRev? | AlphaSnacks | Tuning | 4 | 12-05-2010 03:40 AM |
2nd gear not as smooth as the others??? | VQinside | Engine & Drivetrain | 14 | 11-03-2010 09:22 PM |
UpRev Osiris/Technosquare users- throttle mapping? | SE | Tuning | 3 | 08-29-2010 05:03 PM |
Smooth launch in 1st Gear? | BrianMSmith | Nissan 370Z General Discussions | 22 | 03-26-2010 10:40 PM |