350whp?
 

Hi!

Do anyone now the right way to 350whp without forced induction?? ( if its not to much problem to getr it )..

//Patrik

Trade in for a mustang?

Then i need 550whp and i am at the same place that i started :O

Start with a full set of bolt-on parts IE G3 intakes- FI longtube headers- good Dual exhaust (FI/HKS) -- Pullies and a tune


That should get you around 315-325whp on a mustang dyno




DAN

Then vvel crack. Whenever that happens.

320 full bolt ons . dyno jet/ but the car runs the 1/4 mile in 12.42's
base line 260 to 264. 7 AT.

350 rwhp do not think this is possible

Z

Its possible but its gonna be expensive which you can get supercharege with that money

start with,
ART pipe
Fast intention catback
NST pulley kit
Motordyne manifold
light flywheel and clutch
Stillen Gen3 CAI
Custom Uprev tune

The list above should get you near 330 WHP. After that wait till GTM for there VVEL crack control then that should get you near 350 hopefully.

I got 335 with the list below.
I think 350 might be a bit of a dream

335 on what type of dyno? I see that your missing pulley's, and flywheel. Not sure how your numbers are so hight with only LTH,CBE,Intake, Tune.

I went up to performance motersports (bump for them btw) and used there dyno. Other ppl will be able to tell what dyno.

Some people have thought make an intake manifold but... eh

Yea I think 350WHP with "Juice" or FI is a bit of a dream. There are guys with full bolt ons- LTH and TP's, That make just a hair over 330whp. I'm sitting 298 WHP, And Headers and TPs are not going to give, me 50 WHP.. Maybe after GTM cracks the VVEL?? But no one is even sure what kinda gains thats gonna yield.

Dammm, whats with you and Stangs. He said he wanted 350hp, not 350hp and a mullet.

Haha, I'm just saying it is not happening with the z. Most of the guys laying 330+ are quoting "adjusted" numbers... We aren't even close to 350 capable.

Put in a sbc.

Thanks guys :)

I have a 370z 7AT 2010

Fast Intentions full exhaust
AEM long tube filters

Car makes 316whp / 259 lb /ft Dynojet ( stock 279hp / 237 lb / ft )

You say:

Pulleys
Intake manifold
Uprev

This maight take me to 325-330hp ?

I will try :)

You can see some dynopaper: Garaget | Nissan 370z (2010)