UpRev Tuned - Berk CBE & HFC, Stock intake
 

Incase anyones curious about the combo:
http://i1238.photobucket.com/albums/...nt-1-large.jpg
We ran out of time on the dyno :( so we'll be polishing up the tune in a couple of weeks after I get an intake. I was mainly just curious to see how efficient the stock intake is before I go that route.

It looks like I have some room to lean out the mid-upper range a bit and pull some more power. :driving:

fyi the AFR plot with the large spike to 14.1 is the one before the tune

i'm no expert at all but the HP looks really high for a Mustang dyno... not that it's wrong, you might just have a really good set-up or the Berk HFC and CBE produces more power than any other exhaust combo i've researched. The TQ looks low in comparison to the HP... but again i'm not an expert. I'd be happy with the numbers if if were me... especially since you can squeeze a little more out of the tuning.

The owner actually calls his dyno "the heartbreaker" just like I had heard on the forum so I was preparing myself to be disappointed. Tq should be higher but I'm still very happy with how it turned out. :tup:

I'm not sure if its the Berk combo to be honest. Other dynos I've seen with the Berk exhaust didn't seem too impressive imo. I'm going to do another run on a different dyno sometime in the fall

Solid gains from the tune.

Nice gains from the tune, I had similar numbers on my area mustang also. But I have intakes,but AWD 7spd auto. :)