![]() |
New Software, Up-Rev, now car won't start when Hot!!!
New software. I now have all the VVEL and other stuff that I did not need. Imported the old tune, you have to hand jam all the timing, That Sucked!! Now the car starts good and runs good but will not cold but when the water temp is over 100F.
Any idea what table to start in? If i touch the throttle it will start. The car is a 2010 with a GTM stage 2 SC kit. The reason I upgraded software was new computer old one died!!! |
It’s in the tune. Too much fuel is dumped during hot starts and that’s why you need to add pedal input to add more air to get it started. Had same issue when went to 1050 injectors. Changed to ecutek as per tuner recommendations. Supposedly has more precise injector control. I’m Running same gtm stage 2 supercharger.
|
Updated my tables based on some old tune data, and it worked!!!!
But the Tach now shows 2000 at idle, So I re-flashed again and now I am back to NO Start hot. I may call ECUtek tomorrow. Any idea on how to get a base tune??? |
Changed injectors, looked at some other stuff. Car starts fine cold. On restart (hot) I now have a Bank 1 rich code.
Ordered Up-stream O2, and will look at grounds today. MAF shows good. |
Why are you still
On uprev |
All times are GMT -5. The time now is 12:04 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2