About to EcuTek tune, help with Specialty Z MAP Sensor install
 

Hello All. I have a 2012 G37 with the Stillen SC kit. I am about to start tuning with Seb at specialty Z. I need some help with installing the MAP sensor kit they sell for SD tuning. I am unclear on where to add the new hose barb fitting. Does anyone have a picture of where they installed theirs or can give me some guidance?

Thanks in advance

I think there is a DIY on this site. If you can't find it using the site's search, try any major search engine and add "site:the370z.com" to your search string.
Eg, MAP sensor install site:the370z.com

Thanks for the reply. I tried searching and so far I have been unsuccessful in locating a DIY. If you have a link, that would be awesome. I'll continue searching meanwhile since you said the info exists somewhere

I'm not 100% certain but I think there is a thread where someone had a very similar problem and was able to figure it out. Maybe I just dreamed it.

I couldn't find a thread, but Seb told me what I need to know. Basically, I have to drill a hole in the manifold above the existing hose barb between the throttle bodies and tap it for the new hose barb. Then I use the plug from the existing MAP sensor to connect the new one. Maybe now this thread will help the next person, lol

take pictures before and after. Charles over at CJM is doing my install with his fuel kit.
any upgrade to the SC ?