|
Thanks for the replies. My next set of bolt ons are pulley kit and z1 mani then retune. After much debate in going to skip the headers due to the
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
09-21-2016, 09:15 AM
|
#7 (permalink) |
|
Base Member
Join Date: Sep 2016
Location: Batesville, AR
Posts: 51
Drives: 10 Nissan 370z AT7
Rep Power: 9  |
Thanks for the replies. My next set of bolt ons are pulley kit and z1 mani then retune. After much debate in going to skip the headers due to the cost/headache for the Hp. I will say this about my current set up. My 1/8 time with just the stillen G3 was 9.00. After other bolt ons and a tune I ran 8.55 spinning in 1st and 2nd. I did see an improvement there.
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New ECUTEK tune (Switched from my Uprev dyno tune) by SpecialtyZ | edconline | Tuning | 40 | 03-29-2017 06:00 PM |
| When is it a good idea to do a tune up on our cars? | newls196 | Engine & Drivetrain | 4 | 05-05-2016 02:06 PM |
| Baily's Hyperformance in Texas any good for tune? | AstatenateZ | Tuning | 1 | 04-30-2015 01:47 PM |
| I Need a good Tune in the state of NC or close by | V8Killer | Tuning | 16 | 06-10-2014 09:03 PM |
| Can someone recommend a good mechanic/tune shop in the DC metro area?(not baltimore) | dmhenderson | Mid-Atlantic Region | 13 | 06-13-2012 01:20 PM |
5Likes
Threaded Mode
