Remove jack and tools and anything else for weight savings. 1/4 tank of gas saves weight over a full tank. Bring a helmet. Pay race fee. Go to tech inspection.
|
|
LinkBack | Thread Tools | Display Modes |
11-13-2013, 09:26 PM | #16 (permalink) |
Base Member
Join Date: Oct 2011
Location: Sheboygan Falls WI
Posts: 53
Drives: 15NISMO16Q50RS400AWD
Rep Power: 14 |
Remove jack and tools and anything else for weight savings.
1/4 tank of gas saves weight over a full tank. Bring a helmet. Pay race fee. Go to tech inspection. Park your car and walk up and watch where people are lining up and where the water is that you will want to drive around. And where you will be stopping to light up the 2 sets of yellow staging lights. You will need to pay attention to the track workers that will signal you on when to leave the staging line and move forward, and when to get on the track. Line your car up straight and slowly creep forward until the first set of yellows lights up, and a couple inches forward for the 2nd yellow lights, then hold the brake firm as you are ready to watch the lights and go. You should have the VDC switched off, and the trans in manual mode. You can just stomp on the gas and hold it to the floor the whole run. Watch the lights and try and go in time with the last yellow lighting up just before the green. Try and shift at exactly 7500 but no later as you may end up hitting the rev limiter. After your run slowly come back on the return road and pick up your time slip at the booth.
__________________
Red 2012 370Z Base Sport 7AT, ExoticSpeed CBE, 13.0@109(sold) Q50RS400AWD 12.2@116 JB1 CBE |
11-15-2013, 07:44 PM | #19 (permalink) |
Track Member
Join Date: Apr 2012
Location: earth
Posts: 770
Drives: car
Rep Power: 2067 |
So after all the advise in the end I ran a 13.27 on Micheline PSS and very proud of it. Since it was 43 degrees it helped to do a burn out believe it or not. I almost went into the wall on my very first run ever. So for best times do everything everyone else said but keep your RPM's at 2k so u can get an awesome jump. If u feel urself slipping just barely let off for a millisecond and get back on it. By the 4th run I was doing great. Thnx everyone for the advise
|
11-15-2013, 11:53 PM | #20 (permalink) |
Base Member
Join Date: Jun 2013
Location: palm coast
Posts: 86
Drives: 2013 Base Sport
Rep Power: 12 |
Good to hear. It sounds like you had a good time, which is most important.
A break down of your slip would be great if you could upload it. If not, the just list: 60' 1/8th time 1/8th MPH 1/4 MPH |
11-17-2013, 10:17 AM | #25 (permalink) |
Base Member
Join Date: Jun 2013
Location: palm coast
Posts: 86
Drives: 2013 Base Sport
Rep Power: 12 |
That makes a little more sense, but still impressive nonetheless. not a bad 60', but if you could get a low 1.9 high 1.8, you would be very boarderline 12's. Sooooo clooosssseeee.
|
11-22-2013, 08:46 AM | #26 (permalink) |
Enthusiast Member
Join Date: May 2013
Location: McAllen,TX
Posts: 457
Drives: '10 370Z Tour A/T
Rep Power: 12 |
He can hit a 12.9 EASY seeing at his reaction time was technically .5th of a second. Hmmm intruiguing I'm gonna reduce weight and hit the track as I hit 13.4's but no weight reductions -.-
__________________
GTM 34 Row Oil Cooler | K&N Drop Ins w/ Z1's Post MAF Tubes | F.I Non-Res'd 2.5" T.P w/ CF CBE | Axis Wheels | Piecing together My Own Custom T4 Top Mount Single Turbo Kit *Still in the works* | |
11-22-2013, 08:47 AM | #27 (permalink) |
Enthusiast Member
Join Date: May 2013
Location: McAllen,TX
Posts: 457
Drives: '10 370Z Tour A/T
Rep Power: 12 |
Hey Flujoke what did you race against?? I must know what you beat!?
__________________
GTM 34 Row Oil Cooler | K&N Drop Ins w/ Z1's Post MAF Tubes | F.I Non-Res'd 2.5" T.P w/ CF CBE | Axis Wheels | Piecing together My Own Custom T4 Top Mount Single Turbo Kit *Still in the works* | |
11-22-2013, 09:20 AM | #30 (permalink) |
Enthusiast Member
Join Date: May 2013
Location: McAllen,TX
Posts: 457
Drives: '10 370Z Tour A/T
Rep Power: 12 |
So your saying if flujoke's reaction time is a full second he's still going to hit 13.2????
__________________
GTM 34 Row Oil Cooler | K&N Drop Ins w/ Z1's Post MAF Tubes | F.I Non-Res'd 2.5" T.P w/ CF CBE | Axis Wheels | Piecing together My Own Custom T4 Top Mount Single Turbo Kit *Still in the works* | |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Best 0-60 (1/8 mile) / (1/4 mile) times with 2013 7SP AT | kenwood | New 370Z Owner | 1 | 11-18-2012 05:20 PM |
1/4 mile time | bigZ | Nissan 370Z General Discussions | 1 | 04-29-2011 11:05 AM |
1/8th Mile time | 5700lucas | Track / Autocross / Drifting / Dragstrip | 18 | 04-18-2011 05:02 PM |
Does anyone's transmission clunk from time to time when pushing the clutch in?? | chitown1863 | Engine & Drivetrain | 21 | 04-13-2010 09:22 AM |
New 1/4 mile time... | ZforMe | Track / Autocross / Drifting / Dragstrip | 19 | 06-03-2009 12:20 AM |