|
Don’t know if Obender was measuring caliper or rotor temps. For rotor temp measurement after a cool down lap, assume OEM Akebonos and no brake cooling ducts: the front rotors
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
09-27-2019, 02:45 PM
|
#18 (permalink) |
|
A True Z Fanatic
Join Date: Jul 2011
Location: Dallas, TX
Posts: 3,259
Drives: 09 Nismo, 16 Nismo
Rep Power: 163995   |
Don’t know if Obender was measuring caliper or rotor temps.
For rotor temp measurement after a cool down lap, assume OEM Akebonos and no brake cooling ducts: the front rotors are just tiny bit bigger than the rear in diameter (355 vs 350mm), but thickness differs greatly (32mm vs 20mm). The front rotors carry a much greater volume of heat with not much more surface area to for heat dissipation. With a method like using an infrared temp gun, which measures surface temp, I would not be surprised there is a temp difference, even if the peak temp during braking may be the same between front and rear rotors.
__________________
Setrab | RE-71 | SPL | JRZ | Nismo | ARK | Whiteline | RacingBrake | CJM Oil Pan | Ti shield |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Intake Air Temperature Help | Cranberry | Engine & Drivetrain | 11 | 08-08-2018 12:55 PM |
| Temperature control in car | JSPEED | Exterior & Interior | 14 | 11-13-2013 12:59 PM |
| Temperature and HP | Troyz | Nissan 370Z General Discussions | 21 | 09-23-2013 05:09 PM |
| Oil temperature | lachap55 | Engine & Drivetrain | 31 | 09-10-2012 06:09 AM |
| Oil Temperature Issues | EventHorizoN | Engine & Drivetrain | 29 | 07-31-2011 09:05 PM |
29Likes
Threaded Mode
