Nissan 370Z Forum  

370Z Forums HOME My Picture Album Nissan 370Z Pictures Premium Membership Become a Forum Sponsor
Go Back   Nissan 370Z Forum > Search Forums
Reload this Page Search Results
Register All Albums FAQDonate Members List Calendar Today's Posts


Page 1 of 3 1 23
Showing results 1 to 25 of 69
Search took 0.01 seconds. Search: Posts Made By: obender66
Forum: Engine & Drivetrain 07-20-2024, 10:08 AM
Replies: 31
Views: 2,349
Posted By obender66
This is pic of JWT CSC. No leaks, but it looks...

This is pic of JWT CSC. No leaks, but it looks off center. Not sure if it means anything at all.
Would be nice to get feedback from JWT-that was $350 part which worked worse and provided less...
Forum: Track / Autocross / Drifting / Dragstrip 07-20-2024, 10:01 AM
Replies: 10
Views: 775
Posted By obender66
Thank you all for comments. I did not supervise...

Thank you all for comments. I did not supervise the tech when corner balance was done-I hope that all the proper steps about disconnecting sway bars were followed. Alignment was done in the same...
Forum: Parts for sale (Private Classifieds) 07-20-2024, 09:17 AM
Replies: 0
Views: 519
Posted By obender66
ACT Streetlite Flywheel

35K km on flywheel. No performance or quality issues. I do a lot of 1-2 gear driving in shitty Toronto traffic, it got tedious. Otherwise feels great at good pace/rpm.
I put stock flywheel back...
Forum: Parts for sale (Private Classifieds) 07-20-2024, 08:56 AM
Replies: 0
Views: 491
Posted By obender66
Whiteline swaybar front end links

Test fitted and gave up. Never driven on them.
Washers were missing from the original package.
My ineptitude=your gain :)
$80USD shipped Continental USA or Canada.

Please note I will be out...
Forum: Track / Autocross / Drifting / Dragstrip 07-09-2024, 06:34 AM
Replies: 10
Views: 775
Posted By obender66
Yes, it was added, I have other screens from tech...

Yes, it was added, I have other screens from tech indicating it.
Forum: Track / Autocross / Drifting / Dragstrip 07-08-2024, 06:00 PM
Replies: 10
Views: 775
Posted By obender66
Z is more difficult to drive after corner balance

Hi all!

Last year I corner balanced the car for the first time (before that I just eyeballed ride height and would jack offending corner up or down a bit :)
Currently I am failing to beat my...
Forum: Brakes & Suspension 07-08-2024, 05:26 PM
Replies: 0
Views: 898
Posted By obender66
Hawk HP+-quality control?

I bought Hawk HP+ for Wilwood caliper (7416 plate).Since Hawk customer service disregarded my inquiry I am going to spill it here.
1) Pad area is smaller compared to Wilwood pad-it will eat groves...
Forum: Engine & Drivetrain 07-08-2024, 04:52 PM
Replies: 31
Views: 2,349
Posted By obender66
Just noticed the thread...I went through a lot of...

Just noticed the thread...I went through a lot of issues with JWT CS installed.
Stock CSC went out at 60K km. I installed ACT street clutch and flywheel with JWT CSC.
In a about 15K I started...
Forum: Engine & Drivetrain 12-10-2022, 08:18 AM
Replies: 3
Views: 1,131
Posted By obender66
You dont have factory oil cooler plate. Easier...

You dont have factory oil cooler plate. Easier access, less disturbance to the plate.
Now anyone else wants to share happy moments?
Forum: Engine & Drivetrain 12-09-2022, 04:46 PM
Replies: 3
Views: 1,131
Posted By obender66
Setrab oil filter sandwich plate?

Has anyone tried Setrab sandwich plate? I keep running into replacing gaskets on Mocal plate (Z1 oil cooler kit) due to leaks springing up. Seem to last anywhere from few years to less than a year....
Forum: Brakes & Suspension 03-26-2022, 03:41 PM
Replies: 20
Views: 2,398
Posted By obender66
Dear OP, Disregard all the critique, go with...

Dear OP,

Disregard all the critique, go with Godspeed stuff. If it works out, you can show a finger to all snobs on this forum. If not- buying shitty parts and dealing with consequences builds...
Forum: Brakes & Suspension 04-13-2021, 04:12 PM
Replies: 47
Views: 13,576
Posted By obender66
Same here-middle screw didn't go in. For those...

Same here-middle screw didn't go in. For those who are reading and planning to install-file the hole down about 1mm extra, should be OK
Forum: Brakes & Suspension 02-20-2021, 10:49 AM
Replies: 31
Views: 6,915
Posted By obender66
I was using Eibach front at soft and stock rear...

I was using Eibach front at soft and stock rear bar for few seasons. It is definitely better set up than stock(my lap times improved)..but car was a bit understeery. I tweaked front/ rear balance...
Forum: Engine & Drivetrain 01-18-2021, 05:52 PM
Replies: 18
Views: 14,666
Posted By obender66
Clutch slave cylinder is finally gone, started...

Clutch slave cylinder is finally gone, started leaking and pedal got really soft. I flushed it (again!) and managed to drive for another 4 weeks until replacement parts have arrived. Was adding bit...
Forum: Brakes & Suspension 08-25-2020, 08:13 AM
Replies: 19
Views: 3,488
Posted By obender66
Good question..i noticed that theres much more...

Good question..i noticed that theres much more deposits right after the slot. Like it shaves a bit off and then those shavings get baked right on.
Forum: Engine & Drivetrain 08-16-2020, 09:39 AM
Replies: 18
Views: 14,666
Posted By obender66
Bringing the thread back from the dead... Any...

Bringing the thread back from the dead...
Any other alternatives to Motul? I am getting dissappointed with it- it is poo brown and yet again I had to take bleed screw out and poke the hole with...
Forum: Brakes & Suspension 08-15-2020, 05:48 AM
Replies: 19
Views: 3,488
Posted By obender66
Any update? I run into that too, but it all...

Any update? I run into that too, but it all clears up in about 3 weeks of street driving. Trying DTC- 60 next time.
https://flic.kr/p/2jwxw9V
Forum: Wheels & Tires 06-25-2020, 08:16 PM
Replies: 728
Views: 288,558
Posted By obender66
Enkei TS10 18x9.5 +35 F 18X10.5 +25 R ...

Enkei TS10
18x9.5 +35 F
18X10.5 +25 R

265/40/18 Yokohama A052 all around
Forum: Audio & Video 04-03-2020, 03:49 PM
Replies: 10
Views: 1,336
Posted By obender66
That's the reason why message boards are dying:...

That's the reason why message boards are dying: RTFM point ran itself out in the 90's. If I wanted to RTFM, I would've effin do that, ain't I?
I want an easy answer...pleaseeeee...?
Forum: Audio & Video 04-03-2020, 12:54 PM
Replies: 10
Views: 1,336
Posted By obender66
Cmon dude, i can barely read and count to 10, u...

Cmon dude, i can barely read and count to 10, u expect me to decypher FSM?
Forum: Audio & Video 04-03-2020, 10:11 AM
Replies: 10
Views: 1,336
Posted By obender66
2016 base USB line?

Hi all,

How is USB line(with port in armrest) connected to stock head unit? Is it buried in factory harness or ran separately with standard USB plugs-plug and play into aftermarket unit? ...
Forum: Brakes & Suspension 02-06-2020, 10:20 AM
Replies: 12
Views: 1,566
Posted By obender66
If spring bucket does not swing freely all the...

If spring bucket does not swing freely all the way down, loosen other nut a little bit(the one which is attaching bucket to subframe). Do not remove it.
Forum: Brakes & Suspension 01-22-2020, 01:17 PM
Replies: 15
Views: 2,154
Posted By obender66
It only looks are concern, then with 1-1.5" drop...

It only looks are concern, then with 1-1.5" drop it will look OK on stock 18".
Not perfect, but definitely not embarrassing. Fronts are a bit narrow and seem to be too recessed.

Regarding...
Forum: Track / Autocross / Drifting / Dragstrip 09-27-2019, 05:25 PM
Replies: 20
Views: 2,300
Posted By obender66
Thank you, that is a great insight. My problem is...

Thank you, that is a great insight. My problem is that it is very difficult to quantify by seat of the pants traction available. Car slows down, I do not crash, I do not get brake fade after 25-30...
Forum: Track / Autocross / Drifting / Dragstrip 09-27-2019, 05:15 PM
Replies: 20
Views: 2,300
Posted By obender66
Yes, there was some cool down, and I agree, they...

Yes, there was some cool down, and I agree, they cool off differently. My fronts probably cool off quicker as they are Wilwood 2 piece with aluminum hats and rear are off the shelf Z33 brembos.
I...
Showing results 1 to 25 of 69
Page 1 of 3 1 23

 
Forum Jump

All times are GMT -5. The time now is 05:44 PM.

Contact Us - Home Page - Archive - Top

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2