Motordyne 4" Ti Exhaust Tips
 

What system where you going to fit them to? Do you know if they will fit the F.I. set up?

F.I. setup? I'm confused, it's for replacing the exhaust tips for a 3" exhaust


What are the holes in the inlet side for?

pm'd

I was gonna chop off my replica HKS tips & screw these on. If your piping is 3" before the tips it will work.

If your exhaust is 3" piping before the tips then it will work. The holes on the inlet side have small bolts that screw on to give tension against the 3" piping. It secures the tips to the exhaust.


Didn't get it.

bump

im going to measure my exhaust... its a greddy spectrum elite... a miss hap happened which caused me to lose the burnt tips :( hopefully these fit ill check my piping tomoro morning

Cool! The inlet of the exhaust tip is 3" and the tip is 4". As long as your outlet is 3" you can bolt these on. You might have to cut the tip off.

i just checked it bro :tup: they are indeed 4'' and the inlets are 3'' but the only way this will work is if i cut off the greddy tips..... which im not really sure i wanna do :(

^ Get it!

hey you korean? I'm Korean too! :) where do you live? I wish you live closely by so i can see them in person!

^ Yes I am. But I live in Socal.