Nissan Flowgo

k67p67

Love it! I've been wanting to do something with the new logo. Any thoughts about adding some kind of mesh to keep debris from striking filter elements?

__________________
SOLD2017 370Z Nismo Tech 6MT PART OUT IN PROGRESS
Work | Motordyne | Powertrix | Swift | Michelin | Takeda | Hotchkis | RJM | Voodoo13 | SPL | SPC | Z1 Motorsports | ZSpeed | Morimoto | Craft Square

ZStalker505

Dig it but up close they look a little unfinished. Only interest I'd have would be for more cooling air flow and no idea if it would make much difference on a SC application.

DarkJak

Hard stuff would hit the plastic backing on the styles that flow left/right or one direction only. The fully flow through one wouldn't have anything. I think cutting metal mesh would be more effective than printing, but adding printed mesh wouldn't be too hard.

For finish, ASA is very sandable. Similar to ABS.

__________________
@stupidtoycars | My track vids
09 7AT|MCS 2WNR|Topgunz Rotrex|Ecutek (Eugene)|Maxxis RC1|Titan-7 TS-5|OSG LSD|Rear Mount Derale Oil Cooler (WIP)+25 Trans Cooler|Fismo|G-LOC R12/R10|Zeta III L|NLR Wing and Splitter|CJM Pan and Fuel Hat|Radium Surge Tank|AP Racing CP9668