RJM adjustable clutch pedal

Kamillio · 04-30-2018, 10:15 AM

SOLD

The best driving experience change you can make to your Z. You can adjust your clutch pedal engagement and length of the stroke to your taste and get rid of the horrible high pedal clutch bite.

ONLY SELLING BECAUSE I DON'T HAVE THE CAR ANYMORE

Sent from my iPhone using Tapatalk

JARblue · 04-30-2018, 10:16 AM

What version? Looks like V3?

*edit* it is Rev 2.1

This is great addition to any Z! GLWS

Kamillio · 04-30-2018, 10:30 AM

Quote:

Originally Posted by JARblue

What version? Looks like V3?

It's Rev 2. I can send the installation instruction PDF to the new owner.

Sent from my iPhone using Tapatalk

wildmike85 · 04-30-2018, 05:16 PM

What’s the difference in the revisions?

Asus_ · 04-30-2018, 06:48 PM

Quote:

Originally Posted by wildmike85

What’s the difference in the revisions?

RJM Clutch Pedal System for 370Z - Fully Customizable Clutch Feel & Stroke

Quote:

For the Rev3 visually it doesn't look that different from a Rev2 however it was completely redesigned from the foot pad up and there isn't a single piece left in common with the older units. The changes all focused on ease of install and ease of tuning... So the number of adjustment points and range of adjustment remained virtually unchanged. When a Rev2 and Rev3 are setup equally you shouldn't be able to tell them apart by driving feel unless you look under the dash.
The key new features are that the Rev 3 now comes with the upper pedal arm fully installed in the main bracket. Everything is greased, upper arm in place, spring in place and it all goes up onto the firewall as a complete assembly ready to go.
The AFP adjustment is now a simple sliding plate with an indicator window to show you what the AFP is set for.
The AFP now comes pre-setup so all you do is bolt it in and its already at the magic starting point I recommend.
The upper switch now has a simple moveable mount that adjusts with loosening just one Allan head bolt for quick adjustment. No more jam nuts to mess with.
The Rev3 uses the OEM clevis end on the master cylinder so you no longer need to remove and replace it. Since the clutch rod setting was ok with the OEM pedal and the clevis doesn't need to be touched anymore you can go straight to test driving without needing to do any further setup with it. Just fine tune later if needed.
The Rev3 bracket design is more open and allows better access around the master cylinder studs so it's easier to see them, start the nuts and tighten them down with less obstructions. In Rev 3.1 this got improved even a little more as additional clearance was given beside the upper left stud to help with starting the nut.

So that means:
No more installing of the bare main bracket on the firewall first.
No more greasing & installing the bearings into the pivot tube under the dash.
No more greasing and installing the spring under the dash.
No more having to line up the pedal arm in place under dash, while keeping the spring from falling off and pushing the large clevis pin thru to hold everything together.
No more double jam nuts to fight with when adjusting the upper cruise control switch depth which needs to done when making other setup changes.
No more need to setup the initial AFP starting point during the install.
No more counting the number of turns of the AFP adjuster and estimating where it's setup for or worse yet turning the wrong direction and wondering why it's not responding how you want it.

So basically a lot of little things that when all put together make the Rev3 MUCH easier to install, tune and understand what needs to be done compared with the Rev2.

OP's price isn't bad but for another $90 you can get Rev3 which based on the info above makes for a much smoother install etc..

Kamillio · 04-30-2018, 08:32 PM

Quote:

Originally Posted by Asus_

RJM Clutch Pedal System for 370Z - Fully Customizable Clutch Feel & Stroke

OP's price isn't bad but for another $90 you can get Rev3 which based on the info above makes for a much smoother install etc..

Maybe Rev 3 is easier to install, but Rev 2 was never a hard job to install. If you change your oil, then you can install this. 90+20 shipping, if you want to pay that then go ahead and buy Rev 3.

Sent from my iPhone using Tapatalk

Asus_ · 05-01-2018, 06:10 PM

Quote:

Originally Posted by Kamillio

Maybe Rev 3 is easier to install, but Rev 2 was never a hard job to install. If you change your oil, then you can install this. 90+20 shipping, if you want to pay that then go ahead and buy Rev 3.

Sent from my iPhone using Tapatalk

Personally, as soon as i saw your thread i was about to jump on it and noticed it was Rev 2, i searched up the differences between them and decided 120 is not much more to pay but thats me lol.

To be fair tho the rev 2 is the same performance, and 120 is still savings for those who want it, was just trying to let you know why i changed my mind incase others might have or will as well. Goodluck with sale either way, this is an amazing product and no different than the Rev 3 other than cosmetic!

Quote:

For the Rev3 visually it doesn't look that different from a Rev2 however it was completely redesigned from the foot pad up and there isn't a single piece left in common with the older units. The changes all focused on ease of install and ease of tuning... So the number of adjustment points and range of adjustment remained virtually unchanged. When a Rev2 and Rev3 are setup equally you shouldn't be able to tell them apart by driving feel unless you look under the dash.
The key new features are that the Rev 3 now comes with the upper pedal arm fully installed in the main bracket. Everything is greased, upper arm in place, spring in place and it all goes up onto the firewall as a complete assembly ready to go.
The AFP adjustment is now a simple sliding plate with an indicator window to show you what the AFP is set for.
The AFP now comes pre-setup so all you do is bolt it in and its already at the magic starting point I recommend.
The upper switch now has a simple moveable mount that adjusts with loosening just one Allan head bolt for quick adjustment. No more jam nuts to mess with.
The Rev3 uses the OEM clevis end on the master cylinder so you no longer need to remove and replace it. Since the clutch rod setting was ok with the OEM pedal and the clevis doesn't need to be touched anymore you can go straight to test driving without needing to do any further setup with it. Just fine tune later if needed.
The Rev3 bracket design is more open and allows better access around the master cylinder studs so it's easier to see them, start the nuts and tighten them down with less obstructions. In Rev 3.1 this got improved even a little more as additional clearance was given beside the upper left stud to help with starting the nut.

So that means:
No more installing of the bare main bracket on the firewall first.
No more greasing & installing the bearings into the pivot tube under the dash.
No more greasing and installing the spring under the dash.
No more having to line up the pedal arm in place under dash, while keeping the spring from falling off and pushing the large clevis pin thru to hold everything together.
No more double jam nuts to fight with when adjusting the upper cruise control switch depth which needs to done when making other setup changes.
No more need to setup the initial AFP starting point during the install.
No more counting the number of turns of the AFP adjuster and estimating where it's setup for or worse yet turning the wrong direction and wondering why it's not responding how you want it.

So basically a lot of little things that when all put together make the Rev3 MUCH easier to install, tune and understand what needs to be done compared with the Rev2.

Kamillio · 05-20-2018, 02:44 AM

Bump

Sent from my iPhone using Tapatalk

6MT>7AT · 05-21-2018, 02:15 PM

PM'd

Kamillio · 05-30-2018, 04:48 PM

Buyer backed out. TTT

Gvllardo · 05-31-2018, 11:26 PM

still got it?

Kamillio · 05-31-2018, 11:27 PM

Yes I do

Sent from my iPhone using Tapatalk

Akshaya · 06-01-2018, 12:47 AM

This is a great price. I bought one a couple days ago and I ended up paying 320.99 shipped! The only difference is that I got the rev 3.1 and the optional heavy duty machined clevis end. GLWS!

Sent from my iPhone using Tapatalk

Kamillio · 06-01-2018, 08:06 AM

Quote:

Originally Posted by Akshaya

This is a great price. I bought one a couple days ago and I ended up paying 320.99 shipped! The only difference is that I got the rev 3.1 and the optional heavy duty machined clevis end. GLWS!

Sent from my iPhone using Tapatalk

Thanks for the support. Enjoy your clutch pedal!

Sent from my iPhone using Tapatalk

Kamillio · 06-02-2018, 01:20 PM

ttt

04-30-2018, 10:15 AM	#1 (permalink)
Kamillio Enthusiast Member Join Date: Mar 2015 Location: FL Posts: 445 Drives: N/A Rep Power: 51	RJM adjustable clutch pedal SOLD The best driving experience change you can make to your Z. You can adjust your clutch pedal engagement and length of the stroke to your taste and get rid of the horrible high pedal clutch bite. ONLY SELLING BECAUSE I DON'T HAVE THE CAR ANYMORE Sent from my iPhone using Tapatalk CapDown likes this. __________________ 370z Last edited by Kamillio; 11-06-2018 at 10:05 PM.

04-30-2018, 10:16 AM	#2 (permalink)
JARblue A True Z Fanatic Join Date: Mar 2011 Location: Austin, TX Age: 43 Posts: 36,450 Drives: 11 Z34, 98 E36 M3 Rep Power: 2684440	What version? Looks like V3? edit it is Rev 2.1 This is great addition to any Z! GLWS TBatt likes this. __________________ 2011 370Z 6MT Sport Gun Metallic \| ARC \| CJM \| Ecutek \| FI \| Fujimura \| R2C \| SPL \| Stillen \| TWM \| Z1 \| ZSpeed \| Last edited by JARblue; 04-30-2018 at 10:49 AM.

05-20-2018, 02:44 AM	#8 (permalink)
Kamillio Enthusiast Member Join Date: Mar 2015 Location: FL Posts: 445 Drives: N/A Rep Power: 51	Bump Sent from my iPhone using Tapatalk __________________ 370z

05-30-2018, 04:48 PM	#10 (permalink)
Kamillio Enthusiast Member Join Date: Mar 2015 Location: FL Posts: 445 Drives: N/A Rep Power: 51	Buyer backed out. TTT __________________ 370z

05-31-2018, 11:27 PM	#12 (permalink)
Kamillio Enthusiast Member Join Date: Mar 2015 Location: FL Posts: 445 Drives: N/A Rep Power: 51	Yes I do Sent from my iPhone using Tapatalk __________________ 370z

04-30-2018, 05:16 PM	#4 (permalink)
wildmike85 Base Member Join Date: Dec 2017 Location: tx Posts: 7 Drives: ‘15 6MT Rep Power: 7	What’s the difference in the revisions?

05-21-2018, 02:15 PM	#9 (permalink)
6MT>7AT Base Member Join Date: Feb 2018 Location: Long Island Posts: 14 Drives: 08 G37S Rep Power: 7	PM'd

05-31-2018, 11:26 PM	#11 (permalink)
Gvllardo Base Member Join Date: Jun 2017 Location: Orange County Posts: 54 Drives: 09 Nissan 370z 7A Rep Power: 8	still got it?

06-01-2018, 12:47 AM	#13 (permalink)
Akshaya Base Member Join Date: Nov 2016 Location: Kent Posts: 153 Drives: 15 Nissan 370z Nismo Rep Power: 8	This is a great price. I bought one a couple days ago and I ended up paying 320.99 shipped! The only difference is that I got the rev 3.1 and the optional heavy duty machined clevis end. GLWS! Sent from my iPhone using Tapatalk

06-02-2018, 01:20 PM	#15 (permalink)
Kamillio Enthusiast Member Join Date: Mar 2015 Location: FL Posts: 445 Drives: N/A Rep Power: 51	ttt __________________ 370z

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
RJM Clutch Pedal System for 370Z - Fully Customizable Clutch Feel & Stroke	Ryan @ RJM	Drivetrain/Engine	612	03-17-2023 11:38 PM
[FOR SALE] RJM V2 Adjustable Clutch Pedal	TBatt	Parts for sale (Private Classifieds)	4	09-11-2017 05:34 PM
[FOR SALE] RJM Clutch Pedal System for 370Z - Fully Customizable Clutch Feel & Stroke RJM Clutch	law2004	Parts for sale (Private Classifieds)	8	11-15-2015 08:45 PM
[FOR SALE] RJM A.F.P. Fully Adjustable Replacement Clutch Pedal (for 6MT)	Lippstuh	Parts for sale (Private Classifieds)	8	12-17-2014 06:20 PM
Rattling clutch with clutch pedal depressed.	Spooler	Engine & Drivetrain	0	11-07-2014 11:04 PM