Lots of Goodies: Motordyne, Stillen, Soho Motorsports, Enkei Wheels,TBs

vil9j · 12-20-2017, 02:40 PM

All items are located in Southern California Region. NO SHIPPING ON LARGE ITEMS SUCH AS EXHAUST AND EXTERIOR*Photos will be uploaded once all are removed from vehicle. Going back to stock for dealer. LoCal Pick up preferred. Text 9095499376 for quicker response

EXHAUST CLIP: https://youtu.be/VW8cCo8Q8M0

1.Stillen Front Fascia with Brake Duct Fangs, Mesh, and Splitter*Do note that this is a track and daily car. So there are lots of rock chips on the bumper. Mesh on outer edges were trimmed to fit DRLs(custom mounting kit not included for drls).RODS ARE INCLUDED. The end tips where the fender connects to bumper does show some stress cracking in the paint but if you're going to repaint the bumper a good shop should be able fix it. The splitter has taken a beating throughout it's use so it is somewhat warped and scraped. -Sold
Original price($1200+ with body work and accessories)

2. Motordyne Plenum signed by 370z designer Randy Rodriguez and FormulaD Drifter Chris Forseberg-SOLD

3. Motordyne Art Pipes-$SOLD(400 w/ OEM Cats/Test Pipes)

4.Motordyne Y Pipe Resonated-SOLD

5. Beluga Y-Back with custom dump pipe valve opener and switch-250$
Paid Price-$450

6. Injen Long Tube Intake replaced with 3 inch Spectre Air Filters (Modified to not taper at MAF section. Will need a tune after install)-SOLD

7.Soho Motorsports Ported Lower Intake Manifold-$]SOLD

8. Ported Throttle Bodies 63mm *Photo with green in center is oem-SOLD

9. Enkei RS05RR- Gunmetal Rim (Size: Front 18x10 / Offset: +22 / PCD: 5x114.3...Rear:Gunmetal 18x10.5 +15 5x114.3
3/4 Tires are like new. Rears are continental dws and front Lionhart. Not the best but better for the season
Price:SOLD
11. Fly1Motorsports Duckbill. *There is 2 small nicks on the rear and 2 small hairline scrapes that look like they were from rocks or an angry individual with a knife that slid it across. As you can see in the photos they are barely noticeable unless you're told about it or feeling it. Some sections have been touched up - SOLD

12. Fly 1 Carbon Side Blades(Short to allow mudguards)
Driver side has quarter size chip in the very front. Flex cracks in the inner edge due to flexing(noticeable only when upclose).Passenger side was replaced with a new one Sept 2017 - 250$

15370z · 12-20-2017, 02:46 PM

Is the duckbill carbon fiber? Condition?

vil9j · 12-20-2017, 04:01 PM

Duck bill is carbon fiber. Condtion is 8/10 due to a small knick at the top back center edge. Which is why price is low.

BlKsUbYkId · 12-20-2017, 04:53 PM

Might be interested in a few parts. Will wait until you have the parts off and upload photos.

AllOut370z · 12-20-2017, 11:14 PM

What size are the tires on the wheels?

vil9j · 12-21-2017, 12:16 AM

Quote:

Originally Posted by AllOut370z

What size are the tires on the wheels?

285 35 18 front and 295 35 18 rear

Sent from my LG-H931 using Tapatalk

Zoren 370 · 12-21-2017, 06:00 AM

First Dibs on the TB and Injen.

Pmd...send pictures when taken off. Thanks

Louievee0413 · 12-21-2017, 03:55 PM

Your z is by far the Best looking one on this forum.. The setup was perfect..

Off topic.... but free bump! GLWS

longlivethez · 12-21-2017, 10:02 PM

Are the side blades the full length ones or the short ones?

Selling the rear diffuser too, by chance?

Why are you selling all this stuff, anyway?

Breadz · 12-22-2017, 12:37 AM

God damnit i just bought new sideblades. how much do you want for rear spats+vortex gens?

Bigpapi · 12-22-2017, 01:29 AM

Lemme know if you decide to ship items. Highly interested in duckbill, side blades and intakes.

vil9j · 12-22-2017, 04:03 PM

Quote:

Originally Posted by Louievee0413

Your z is by far the Best looking one on this forum.. The setup was perfect..

Off topic.... but free bump! GLWS

Thanks man i appreciate it.

vil9j · 12-22-2017, 04:04 PM

Quote:

Originally Posted by longlivethez

Are the side blades the full length ones or the short ones?

Selling the rear diffuser too, by chance?

They are the short ones. and diffuser has already been sold.

vil9j · 12-22-2017, 04:04 PM

Quote:

Originally Posted by Breadz

God damnit i just bought new sideblades. how much do you want for rear spats+vortex gens?

Not available.

vil9j · 12-22-2017, 04:05 PM

Quote:

Originally Posted by Bigpapi

Lemme know if you decide to ship items. Highly interested in duckbill, side blades and intakes.

I will be removing everything this weekend and get shipping quotes. Keep a look out.

12-20-2017, 02:40 PM	#1 (permalink)
vil9j Track Member Join Date: May 2013 Location: SoCal Posts: 784 Drives: 370z Cpe Sprt '13 MT Rep Power: 13	Lots of Goodies: Motordyne, Stillen, Soho Motorsports, Enkei Wheels,TBs All items are located in Southern California Region. NO SHIPPING ON LARGE ITEMS SUCH AS EXHAUST AND EXTERIORPhotos will be uploaded once all are removed from vehicle. Going back to stock for dealer. LoCal Pick up preferred. Text 9095499376 for quicker response EXHAUST CLIP: https://youtu.be/VW8cCo8Q8M0 1.Stillen Front Fascia with Brake Duct Fangs, Mesh, and SplitterDo note that this is a track and daily car. So there are lots of rock chips on the bumper. Mesh on outer edges were trimmed to fit DRLs(custom mounting kit not included for drls).RODS ARE INCLUDED. The end tips where the fender connects to bumper does show some stress cracking in the paint but if you're going to repaint the bumper a good shop should be able fix it. The splitter has taken a beating throughout it's use so it is somewhat warped and scraped. -Sold Original price($1200+ with body work and accessories) 2. Motordyne Plenum signed by 370z designer Randy Rodriguez and FormulaD Drifter Chris Forseberg-SOLD 3. Motordyne Art Pipes-$SOLD(400 w/ OEM Cats/Test Pipes) 4.Motordyne Y Pipe Resonated-SOLD 5. Beluga Y-Back with custom dump pipe valve opener and switch-250$ Paid Price-$450 6. Injen Long Tube Intake replaced with 3 inch Spectre Air Filters (Modified to not taper at MAF section. Will need a tune after install)-SOLD 7.Soho Motorsports Ported Lower Intake Manifold-$]SOLD 8. Ported Throttle Bodies 63mm Photo with green in center is oem-SOLD 9. Enkei RS05RR- Gunmetal Rim (Size: Front 18x10 / Offset: +22 / PCD: 5x114.3...Rear:Gunmetal 18x10.5 +15 5x114.3 3/4 Tires are like new. Rears are continental dws and front Lionhart. Not the best but better for the season Price:SOLD 11. Fly1Motorsports Duckbill. There is 2 small nicks on the rear and 2 small hairline scrapes that look like they were from rocks or an angry individual with a knife that slid it across. As you can see in the photos they are barely noticeable unless you're told about it or feeling it. Some sections have been touched up - SOLD 12. Fly 1 Carbon Side Blades(Short to allow mudguards) Driver side has quarter size chip in the very front. Flex cracks in the inner edge due to flexing(noticeable only when upclose).Passenger side was replaced with a new one Sept 2017 - 250$ __________________ POWERTRIX UL COILS W/ SWIFT SPRINGS \| STILLEN PULLEY \| MOTORDYNE INTAKE MANIFOLD \| STILLEN GEN 3 INTAKES \| MOTORDYNE ART PIPES \| MOTORDYNE Y-PIPE RESONATED \| MEISTERSCHAFT MIDPIPE \| MEISTERSCHAFT AXEL-BACK \| NITTO NT-05 TIRES \| SPL REAR-CAMBER-ARMS \| UPREV TUNE\| WHP Last edited by vil9j; 03-06-2018 at 06:58 PM.

12-20-2017, 04:01 PM	#3 (permalink)
vil9j Track Member Join Date: May 2013 Location: SoCal Posts: 784 Drives: 370z Cpe Sprt '13 MT Rep Power: 13	Duck bill is carbon fiber. Condtion is 8/10 due to a small knick at the top back center edge. Which is why price is low. __________________ POWERTRIX UL COILS W/ SWIFT SPRINGS \| STILLEN PULLEY \| MOTORDYNE INTAKE MANIFOLD \| STILLEN GEN 3 INTAKES \| MOTORDYNE ART PIPES \| MOTORDYNE Y-PIPE RESONATED \| MEISTERSCHAFT MIDPIPE \| MEISTERSCHAFT AXEL-BACK \| NITTO NT-05 TIRES \| SPL REAR-CAMBER-ARMS \| UPREV TUNE\| WHP

12-20-2017, 04:53 PM	#4 (permalink)
BlKsUbYkId Base Member Join Date: Nov 2012 Location: Socal Posts: 190 Drives: '13 PG Nismo Rep Power: 13	Might be interested in a few parts. Will wait until you have the parts off and upload photos. vil9j likes this.

12-21-2017, 06:00 AM	#7 (permalink)
Zoren 370 A True Z Fanatic Join Date: Mar 2012 Location: FL Posts: 11,018 Drives: 11 Nissan 370 M6 Rep Power: 1913654	First Dibs on the TB and Injen. Pmd...send pictures when taken off. Thanks vil9j likes this.

12-21-2017, 03:55 PM	#8 (permalink)
Louievee0413 Enthusiast Member Join Date: Mar 2017 Location: Islandia Ny Posts: 312 Drives: 2013 Nissan 370z Rep Power: 9	Your z is by far the Best looking one on this forum.. The setup was perfect.. Off topic.... but free bump! GLWS vil9j likes this. __________________ / Evo R DRL / IJDMTOY Rocket bunny lights / Art pipes / Tomei / Gen 3 intake / Concept Z / Bc Coilovers / Z1 / Z Speed / SPC / Last edited by Louievee0413; 12-21-2017 at 09:54 PM.

12-20-2017, 02:46 PM	#2 (permalink)
15370z Base Member Join Date: Aug 2017 Location: Inman,sc Posts: 105 Drives: 15 Nissan 370Z RD MT Rep Power: 8	Is the duckbill carbon fiber? Condition?

12-20-2017, 11:14 PM	#5 (permalink)
AllOut370z Base Member Join Date: Feb 2016 Location: Los Angeles Posts: 55 Drives: Black 370z Rep Power: 10	What size are the tires on the wheels?

12-21-2017, 10:02 PM	#9 (permalink)
longlivethez Base Member Join Date: May 2016 Location: Phoenix Posts: 105 Drives: 2014 370Z Roadster Rep Power: 163	Are the side blades the full length ones or the short ones? Selling the rear diffuser too, by chance? Why are you selling all this stuff, anyway?

12-22-2017, 12:37 AM	#10 (permalink)
Breadz Base Member Join Date: Jan 2015 Location: Clovis Cali Posts: 240 Drives: 12 370z sport 6mt GM Rep Power: 11	God damnit i just bought new sideblades. how much do you want for rear spats+vortex gens? __________________ Fast Intentions Non res CF, CF Duckbill, Stillen G3, Fujimura Diffuser, Swift Springs, 180 Headlights, Forgestar F14Bronze

12-22-2017, 01:29 AM	#11 (permalink)
Bigpapi Base Member Join Date: May 2017 Location: Michigan Posts: 42 Drives: Stock 2012 370z Rep Power: 8	Lemme know if you decide to ship items. Highly interested in duckbill, side blades and intakes.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
SOHO Motorsports & Ecutek Tuning	Nik@SOHO	Tuning	177	08-28-2018 08:57 PM
[FOR SALE] Lots of GOODIES of my Z	AstatenateZ	Parts for sale (Private Classifieds)	24	06-22-2015 09:55 AM
Soho Motorsports Single Exhaust	martin82	Intake/Exhaust	4	02-13-2015 02:15 PM
[FOR SALE] NuGenZBoss PART OUT!!! (Lots of goodies)	nugenzboss	Parts for sale (Private Classifieds)	49	04-04-2014 07:54 AM