Injen SP Tuned Cold Air Intake*
 

Practically brand new, been in the car maybe a week and a half and a couple hundred miles. Going to go a different direction so they are redundant. New reservoir hasn't even been filed with washer fluid yet! Expensive lesson, I know :)

Here's an installed picture. It is still on the car and will take off in about a week. All pieces are included right down to the nuts and bolts and instructions.

http://imagizer.imageshack.us/v2/450...924/Wx21zt.jpg

Here's a link for the full info on the setup if you aren't familiar.
https://www.vividracing.com/catalog/...jqgd3q15smrgs4

Looking for $375 + shipping. PayPal fees inclusive.

Friday would be such a great day to invest in some cold air :)

You're local. Can we meet up tomorrow?

Yes, during the day works for me until about dinner time.

Keep in mind as mentioned in the original post they are still on the car. However if this is a sure thing then I will make time to take them off and put my stock setup back on for the time being.

I can even trade you fillernecks for the cut one needed for this install.

is this sold?

Not yet, I haven't heard back from slideways yet. I'll send him a pm in case he might see that sooner than the reply in the thread.

sir, if you wouldnt mind, PM me best priced shipped to 30179 zip code and we might have a sale.. Thank you

I'll have to pull it off and pack it up to get shipping quote. Want to give slideways a bit of a chance too since it's less than 24hrs since he spoke up.

I've got my whole front clip off right now doing some work so between today and tomorrow I'll have it off and pack it up.

sounds fair... just please let me know sir.. Much appreciated

If you're interested in selling the replacement reservoir or have an extra one, I need one. :hello:

Bump. Off the car and ready to go

Going to hold off on this one over the weekend. I got the Stillen one that is the replacing the I Jen installed this afternoon and so far I think I like the Injen better, so will give it a couple days to give it a chance and make final decision.

At that point either the nearly new Injen or a brand new Stillen G3 will be available.

Bump for the Injen.

After a few days with the Stillen, it is much too quiet for my liking. The Injen also felt a fair bit better on the butt dyno! However, since I'm looking at swapping my rear end and going to 4:08 gears I will be spending more time in the higher rpm range so quieter is probably better in that case. Plus I have a ducting plan in mind for the Stillen.

So with that the Injen is somewhat reluctantly back up for grabs. I already miss the incredibly low burbly sound it offered to my Motordyne setup - it was a fantastic combination and am sure whoever ends up with this intake will appreciate it just as much :)

ugh wish it was black

y didnt you go aem ?

Shipped to 60565.
Thanks