Need Help? Let me know!

bigaudiofanat · 01-02-2010, 11:34 PM

All new speaker wire was ran to the speakers and to the new tweeters. The original plan was to build up a mount with wood and bondo the tweeters into the sides of the doors. "might still do" but we will first test the system with the stock locations and see how it sounds and go from there. It would look slick and would probably give him better imaging. As I said still up in the air. Tomorrow I will be working on the fuse mount for the crv and painting that. Than Friday we will get back together install the amp either under the seat or in another location. As we have said we are not sure what we are going to do about the sub yet but it will probably be a custom box build. Which I will look forward to. Other minor things will be remounting the blu tooth mic. the sad part about this is that the pioneer is already producing a low wine noise "always with pioneers" so I will probably ground the rca's and change the ground point see if that helps. Might be changing the head unit but that is up to Adam and what the turnout is. It is going to turn out to be a good setup.

Did the fuse block bracket

Fuse mount looks good. Up here in North Jersey, I continued with Dynamat. Today, I think it was seven sheets in the trunk. Here are some pics before and after.

Tomorrow, big things happening. PDX-5 amp which was finally delivered being installed, dynamat to the floors/liftgate, mount the crossovers, bluetooth mic, put everything back together again the ... yeah, listen to and tune it.

bigaudiofanat · 01-02-2010, 11:38 PM

Drove down yesterday to continue work with Matt (after spending the day before putting in my trunk Dynamat, as shown above). Wrapped up everything nicely - Dynamat to the floors, amp installed, custom fuse bracket and sheet metal bluetooth mic bracket installed. The Alpine PDX-5 is awesome - so small and the verification sheet from the factory - well, a pic is below; obviously they severely underrate the powerhandling ability of them. I'll let Matt fill in any details from yesterday i'm forgetting. Again, can't recommend working with him highly enough. Learned a lot yesterday and his attention to detail is very significant.

bigaudiofanat · 01-02-2010, 11:38 PM

bigaudiofanat · 01-02-2010, 11:39 PM

bigaudiofanat · 01-02-2010, 11:40 PM

bigaudiofanat · 01-03-2010, 02:31 PM

Should have a website up soon!

bigaudiofanat · 01-06-2010, 09:05 AM

New year bump

fairladyZ34 · 01-07-2010, 01:02 AM

i was wondering if a 6.5 inch sub would fit in the rear speaker opening for the 370z? it would seem kinda cool to pull off and would save trunk space

bigaudiofanat · 01-07-2010, 09:28 AM

No not only are the spaces only made for 3.5 inch speakers but it would be poor placement as well.

thezmonster · 01-10-2010, 10:10 PM

Rear fog light :the best way to connect power is in the ingition ? will it affect the lights at all? no fuse or resistor needed?

bigaudiofanat · 01-11-2010, 07:27 PM

PM sent

bigaudiofanat · 01-13-2010, 09:19 AM

Worked on another car yesterday. This one I got involved in working with bondo. I am still working on the pods and going to get paint soon for them but I do not think they came out bad for a first time.

0 Gauge ran

bigaudiofanat · 01-21-2010, 07:28 PM

Should have more pics up soon.

370ZWhite · 01-31-2010, 04:01 PM

Hey Matt,
How much does it cost to install a Kenwood 6140, including steering wheel wiring, for a 370z? I have a factory radio, no navigation, no Bose.

bigaudiofanat · 01-31-2010, 08:32 PM

PM Sent

01-02-2010, 11:34 PM	#91 (permalink)
bigaudiofanat Car Audio Installer Join Date: Jun 2009 Location: Magnolia DE Posts: 8,342 Drives: 2012 Infiniti G37x Rep Power: 853	All new speaker wire was ran to the speakers and to the new tweeters. The original plan was to build up a mount with wood and bondo the tweeters into the sides of the doors. "might still do" but we will first test the system with the stock locations and see how it sounds and go from there. It would look slick and would probably give him better imaging. As I said still up in the air. Tomorrow I will be working on the fuse mount for the crv and painting that. Than Friday we will get back together install the amp either under the seat or in another location. As we have said we are not sure what we are going to do about the sub yet but it will probably be a custom box build. Which I will look forward to. Other minor things will be remounting the blu tooth mic. the sad part about this is that the pioneer is already producing a low wine noise "always with pioneers" so I will probably ground the rca's and change the ground point see if that helps. Might be changing the head unit but that is up to Adam and what the turnout is. It is going to turn out to be a good setup. Did the fuse block bracket Fuse mount looks good. Up here in North Jersey, I continued with Dynamat. Today, I think it was seven sheets in the trunk. Here are some pics before and after. Tomorrow, big things happening. PDX-5 amp which was finally delivered being installed, dynamat to the floors/liftgate, mount the crossovers, bluetooth mic, put everything back together again the ... yeah, listen to and tune it. __________________ Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/

01-02-2010, 11:38 PM	#92 (permalink)
bigaudiofanat Car Audio Installer Join Date: Jun 2009 Location: Magnolia DE Posts: 8,342 Drives: 2012 Infiniti G37x Rep Power: 853	Drove down yesterday to continue work with Matt (after spending the day before putting in my trunk Dynamat, as shown above). Wrapped up everything nicely - Dynamat to the floors, amp installed, custom fuse bracket and sheet metal bluetooth mic bracket installed. The Alpine PDX-5 is awesome - so small and the verification sheet from the factory - well, a pic is below; obviously they severely underrate the powerhandling ability of them. I'll let Matt fill in any details from yesterday i'm forgetting. Again, can't recommend working with him highly enough. Learned a lot yesterday and his attention to detail is very significant. __________________ Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/

01-02-2010, 11:38 PM	#93 (permalink)
bigaudiofanat Car Audio Installer Join Date: Jun 2009 Location: Magnolia DE Posts: 8,342 Drives: 2012 Infiniti G37x Rep Power: 853	__________________ Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/

01-02-2010, 11:39 PM	#94 (permalink)
bigaudiofanat Car Audio Installer Join Date: Jun 2009 Location: Magnolia DE Posts: 8,342 Drives: 2012 Infiniti G37x Rep Power: 853	__________________ Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/

01-02-2010, 11:40 PM	#95 (permalink)
bigaudiofanat Car Audio Installer Join Date: Jun 2009 Location: Magnolia DE Posts: 8,342 Drives: 2012 Infiniti G37x Rep Power: 853	__________________ Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/

01-03-2010, 02:31 PM	#96 (permalink)
bigaudiofanat Car Audio Installer Join Date: Jun 2009 Location: Magnolia DE Posts: 8,342 Drives: 2012 Infiniti G37x Rep Power: 853	Should have a website up soon! __________________ Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/

01-06-2010, 09:05 AM	#97 (permalink)
bigaudiofanat Car Audio Installer Join Date: Jun 2009 Location: Magnolia DE Posts: 8,342 Drives: 2012 Infiniti G37x Rep Power: 853	New year bump __________________ Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/

01-07-2010, 01:02 AM	#98 (permalink)
fairladyZ34 A True Z Fanatic Join Date: Aug 2009 Location: Central NJ Posts: 1,577 Drives: 08 G37S Black M6 Rep Power: 19	i was wondering if a 6.5 inch sub would fit in the rear speaker opening for the 370z? it would seem kinda cool to pull off and would save trunk space __________________ From Z to G to BMW and back to a G! Nismo for life

01-07-2010, 09:28 AM	#99 (permalink)
bigaudiofanat Car Audio Installer Join Date: Jun 2009 Location: Magnolia DE Posts: 8,342 Drives: 2012 Infiniti G37x Rep Power: 853	No not only are the spaces only made for 3.5 inch speakers but it would be poor placement as well. __________________ Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/

01-10-2010, 10:10 PM	#100 (permalink)
thezmonster Base Member Join Date: Aug 2009 Location: Charlotte Posts: 221 Drives: 09 Nissan 370z CB M6 Rep Power: 16	Rear fog light :the best way to connect power is in the ingition ? will it affect the lights at all? no fuse or resistor needed?

01-11-2010, 07:27 PM	#101 (permalink)
bigaudiofanat Car Audio Installer Join Date: Jun 2009 Location: Magnolia DE Posts: 8,342 Drives: 2012 Infiniti G37x Rep Power: 853	PM sent __________________ Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/

01-13-2010, 09:19 AM	#102 (permalink)
bigaudiofanat Car Audio Installer Join Date: Jun 2009 Location: Magnolia DE Posts: 8,342 Drives: 2012 Infiniti G37x Rep Power: 853	Worked on another car yesterday. This one I got involved in working with bondo. I am still working on the pods and going to get paint soon for them but I do not think they came out bad for a first time. 0 Gauge ran __________________ Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/

01-21-2010, 07:28 PM	#103 (permalink)
bigaudiofanat Car Audio Installer Join Date: Jun 2009 Location: Magnolia DE Posts: 8,342 Drives: 2012 Infiniti G37x Rep Power: 853	Should have more pics up soon. __________________ Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/

01-31-2010, 04:01 PM	#104 (permalink)
370ZWhite Base Member Join Date: Jan 2010 Location: Atlanta, GA Posts: 3 Drives: 2010 370Z White Auto Rep Power: 15	Hey Matt, How much does it cost to install a Kenwood 6140, including steering wheel wiring, for a 370z? I have a factory radio, no navigation, no Bose.

01-31-2010, 08:32 PM	#105 (permalink)
bigaudiofanat Car Audio Installer Join Date: Jun 2009 Location: Magnolia DE Posts: 8,342 Drives: 2012 Infiniti G37x Rep Power: 853	PM Sent __________________ Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/