Please Help! ABS/VDC/Traction Control Problem

eastwest2300 · 01-10-2018, 01:37 PM

All right fellow Z enthusiasts, what do you know about my issue going on? The problem all started with me trying to fix the cruise control sensor, I pressed the button, the indicator light came on, but it wouldnt actually set.. so i unplugged the sensor and started turning the sensor, that didnt fix the problem, im not sure if i was turning it the right way or not. long story short.. i took the car out for a test drive and the brakes squealed a little bit, i didnt think much of it, because the car is hardly driven.

Ultimately, the car immediately lost power and shut off, i noticed a little bit of smoke from the engine bay, it smelled like burn plastic, but it could have been anything. I had to get the car towed back to Madwi's garage. I did notice, the brake pedal looked like it was being pressed without my foot pedal being on the brake. It still looks like that right now. With all 3 sensors being on (ABS, Traction Control, and VDC).

I tried again to adjust the sensor, again taking the car out, and ran into the same problem, luckily i was close to madwi's house. His garage is on a hill, and when the car locked up, gravity should have had the car roll down the hill, but it didnt, even with the ebrake disengaged, and the car not in gear.. but by luck, I dont know why I did it but, i lifted the brake pedal up with my foot and the car rolled back.

Fellas tell me something, any thoughts or insight? I've reached out to Rusty and Ghostvette, they provided me good insight, can anyone else share their experience?

This past weekend, I got the Z up on jack stands (front), the tires off, I inspected the brake lines and wheel speed sensors, I found no damage, I turned the wheels left and right, no issues, however you can still smell a foul smell.

I ordered a new cruise control sensor, and a brake switch sensor. Please help fellas.

SouthArk370Z · 01-10-2018, 04:17 PM

The dropped pedal and locked brakes would have me checking the master cylinder and ABS block. Then I'd look at the calipers.

Edit: I don't think the cruise and brake problems are related. But it's been a long time since I look at that section of the FSM (or any section).

eastwest2300 · 01-10-2018, 06:18 PM

Quote:

Originally Posted by SouthArk370Z

The dropped pedal and locked brakes would have me checking the master cylinder and ABS block. Then I'd look at the calipers.

Edit: I don't think the cruise and brake problems are related. But it's been a long time since I look at that section of the FSM (or any section).

ABS block? Are you talking about the ABS/Actuator fuse (near the battery)?

Thanks SouthArk.

SouthArk370Z · 01-10-2018, 09:12 PM

Quote:

Originally Posted by eastwest2300

... Are you talking about the ABS/Actuator fuse (near the battery)? ...

The module that does all the ABS work. I can't remember the official Nissan name. Big block of metal with brake lines piped to it.

eastwest2300 · 01-10-2018, 09:20 PM

The brake master cylinder?

eastwest2300 · 01-10-2018, 09:21 PM

I believe that IS the central point.

1st · 01-10-2018, 09:32 PM

NO, He is referring to the ABS actuator. It has hard lines to it. Its in that little compartment.

1st · 01-10-2018, 09:33 PM

This is the link to the service manual for breaks, Page BR 22 #6:
Factory Service Manuals - NICO Club

eastwest2300 · 01-10-2018, 09:55 PM

Quote:

Originally Posted by 1st

NO, He is referring to the ABS actuator. It has hard lines to it. Its in that little compartment.

Thanks brother.

eastwest2300 · 01-10-2018, 09:57 PM

Quote:

Originally Posted by 1st

This is the link to the service manual for breaks, Page BR 22 #6:
Factory Service Manuals - NICO Club

sh1t, I had no idea about this.

you learn something new every day. thanks again man, I'll give you boys some repZ tomorrow morning.

SouthArk370Z · 01-10-2018, 10:49 PM

Quote:

Originally Posted by 1st

This is the link to the service manual for breaks, Page BR 22 #6:
Factory Service Manuals - NICO Club

Quote:

Originally Posted by eastwest2300

sh1t, I had no idea about this.

you learn something new every day. thanks again man, I'll give you boys some repZ tomorrow morning.

Since you show having over 66k posts, I figured you would have already found the FSM. It's a great resource for the DIYer.

eastwest2300 · 01-10-2018, 10:59 PM

Quote:

Originally Posted by SouthArk370Z

Since you show having over 66k posts, I figured you would have already found the FSM. It's a great resource for the DIYer.

Ahhh dude, I got it downloaded somewhere around my house.

I just redownloaded all the PDFs again.

Brother, im not sure whats going on man, I mean the car is a 2010 with only 11k miles. I gotta figure it out though man, its really stressing me out.

eastwest2300 · 01-11-2018, 10:59 AM

RepZ given. Thanks fellas.

SouthArk370Z · 01-11-2018, 12:13 PM

Quote:

Originally Posted by SouthArk370Z

Edit: I don't think the cruise and brake problems are related. But it's been a long time since I look at that section of the FSM (or any section).

On second thought, they probably are. With the pedal below normal rest position, it will actuate the switch that tells cruise you are using the brakes.

eastwest2300 · 01-11-2018, 12:38 PM

Quote:

Originally Posted by SouthArk370Z

On second thought, they probably are. With the pedal below normal rest position, it will actuate the switch that tells cruise you are using the brakes.

Yeah, and they gotta be in sync for them to work properly, im going to replace the cruise control sensor because I know for a fact that the CC didnt engage before I started having this problem, but I wont touch the brake switch sensor (even though I already bought it) because I havent touched that and I assume its still good to go..

My coworker was saying to pull the calipers off the rotors, then rotate the rotors to see if the hubs are still good.

01-10-2018, 01:37 PM	#1 (permalink)
eastwest2300 A True Z Fanatic Join Date: May 2010 Location: South FL Posts: 90,973 Drives: '16QX70/'21 Supra3.0 Rep Power: 2684550	Please Help! ABS/VDC/Traction Control Problem All right fellow Z enthusiasts, what do you know about my issue going on? The problem all started with me trying to fix the cruise control sensor, I pressed the button, the indicator light came on, but it wouldnt actually set.. so i unplugged the sensor and started turning the sensor, that didnt fix the problem, im not sure if i was turning it the right way or not. long story short.. i took the car out for a test drive and the brakes squealed a little bit, i didnt think much of it, because the car is hardly driven. Ultimately, the car immediately lost power and shut off, i noticed a little bit of smoke from the engine bay, it smelled like burn plastic, but it could have been anything. I had to get the car towed back to Madwi's garage. I did notice, the brake pedal looked like it was being pressed without my foot pedal being on the brake. It still looks like that right now. With all 3 sensors being on (ABS, Traction Control, and VDC). I tried again to adjust the sensor, again taking the car out, and ran into the same problem, luckily i was close to madwi's house. His garage is on a hill, and when the car locked up, gravity should have had the car roll down the hill, but it didnt, even with the ebrake disengaged, and the car not in gear.. but by luck, I dont know why I did it but, i lifted the brake pedal up with my foot and the car rolled back. Fellas tell me something, any thoughts or insight? I've reached out to Rusty and Ghostvette, they provided me good insight, can anyone else share their experience? This past weekend, I got the Z up on jack stands (front), the tires off, I inspected the brake lines and wheel speed sensors, I found no damage, I turned the wheels left and right, no issues, however you can still smell a foul smell. I ordered a new cruise control sensor, and a brake switch sensor. Please help fellas. __________________ Infiniti QX70 & Toyota Supra 3.0 Premium

01-10-2018, 04:17 PM	#2 (permalink)
SouthArk370Z Premium Member Join Date: Nov 2010 Location: South Arkansas Posts: 8,435 Drives: 2014 Challenger Rep Power: 324198	The dropped pedal and locked brakes would have me checking the master cylinder and ABS block. Then I'd look at the calipers. Edit: I don't think the cruise and brake problems are related. But it's been a long time since I look at that section of the FSM (or any section). eastwest2300 and gbrettin like this. __________________ Steering Lock Links - Search The370Z Bookmarklet - FSM @ NICOclub Mankind has progressed past the need for war but we haven't evolved that far. - NachoMahma Last edited by SouthArk370Z; 01-10-2018 at 04:20 PM.

01-10-2018, 09:20 PM	#5 (permalink)
eastwest2300 A True Z Fanatic Join Date: May 2010 Location: South FL Posts: 90,973 Drives: '16QX70/'21 Supra3.0 Rep Power: 2684550	The brake master cylinder? __________________ Infiniti QX70 & Toyota Supra 3.0 Premium

01-10-2018, 09:21 PM	#6 (permalink)
eastwest2300 A True Z Fanatic Join Date: May 2010 Location: South FL Posts: 90,973 Drives: '16QX70/'21 Supra3.0 Rep Power: 2684550	I believe that IS the central point. __________________ Infiniti QX70 & Toyota Supra 3.0 Premium

01-10-2018, 09:32 PM	#7 (permalink)
1st A True Z Fanatic Join Date: Jul 2012 Location: I 80 Biz U.S. 50 Posts: 1,709 Drives: Platinum Z Rep Power: 1616	NO, He is referring to the ABS actuator. It has hard lines to it. Its in that little compartment. eastwest2300 likes this.

01-10-2018, 09:33 PM	#8 (permalink)
1st A True Z Fanatic Join Date: Jul 2012 Location: I 80 Biz U.S. 50 Posts: 1,709 Drives: Platinum Z Rep Power: 1616	This is the link to the service manual for breaks, Page BR 22 #6: Factory Service Manuals - NICO Club eastwest2300 likes this.

01-11-2018, 10:59 AM	#13 (permalink)
eastwest2300 A True Z Fanatic Join Date: May 2010 Location: South FL Posts: 90,973 Drives: '16QX70/'21 Supra3.0 Rep Power: 2684550	RepZ given. Thanks fellas. 1st likes this. __________________ Infiniti QX70 & Toyota Supra 3.0 Premium

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[FOR SALE] GTM traction control	zuperman 370	Parts for sale (Private Classifieds)	16	09-16-2016 07:34 PM
traction control	wfmrules3	Engine & Drivetrain	19	04-19-2014 10:51 PM
traction control?	RedNismoZ	Nismo 370Z	10	12-30-2011 04:11 PM
Traction Control	ZSPEED	Nissan 370Z General Discussions	10	06-03-2009 06:34 PM