The rear bumper will bolt on, What I did was hack up some old fender liners and made pieces to extend the non nismo liners. I did this front and back.

For the front bumper I did buy the Chin piece so that my belly pan would bolt to the bumper. I just had to drill two new holes and everything lined up nicely.

If you want a true OEM look your gonna want to purchase the liners, I might even in the future do so.

^ good info Funky. Glad to hear the rear bolts on without issues, less the fender liners. Do you know the part numbers for the rear Nismo liners? I can find the part numbers for the front Nismo liners, just not the rear so I wasnt sure it needed them...but looks like it does. The front liners are about $93/each for the Nismo.

Rear fender protector part number is below..

1. H5064 1A47A
2. H5065 1A47A

Can you give me the part number for the front Nismo liners ?

F3845-1A30A (Front inner wheel well liner for one side)
F3844-1A30A (Other side - Without these there is a gap between the sides of the fron bumper and the inner liner of the wheel wells)

Hope this helps

Thank you for your information.
But, those parts are for the front fender liners, do you know the small parts to cover the gap between the front bumper and fender liners ?
I heard that two pieces for each fender and bracket to hold the bumper and under cover.

No offense, but your wheel offset is WAY off, I really dont think the car looks good, maybe some spacers??

how much did the rear run you ?

When you said you used some used liner for front and rear bumper, which liner did you used?

Do you have any close pics? Dealer wants 400$ for both (canadian $) so If I could end up fabricating them myself!

2010.

It's ok, I was taking a chance!! was able to fit my nismo bumper quite easily

https://scontent-yyz1-1.xx.fbcdn.net...bc&oe=58729A7E