Batman Turn Signal for 370z

Mshayegan

Just wanted to know if you can get any customised turn signals for the 370z, or even if you can modify the stock one??

JARblue

I painted mine... no design change though

__________________

Mshayegan

How did you manage to do that??? would you be able to post a picture??

__________________
2010 Nissan 370z 40th Anniversary 'Black Edition'

Chuck33079

Tape off the clear part, sand it and paint it?

__________________
2011 MB Touring-Sport-6sp-Nav/GTM TT/FI TT TDX/JTran/Kosmic/Eibach/Hotchkis/SPC/CSF/RPS/SoThatsWhereAllMyMoneyWent

Mshayegan

Can you just yank off the 'Z' emblem off the turn signal?

__________________
2010 Nissan 370z 40th Anniversary 'Black Edition'

JARblue

I highly doubt it. It's either molded or glued on. Probably difficult to remove and even if you do, it wouldn't be very clean.

__________________

JARblue

I didn't remove the tape properly and have a couple of spots where the paint peeled. Since I used the DupliColor Shadow (it is a translucent coating), I'll eventually redo it without taping anything. It will just make the smoked lens a little darker.

__________________

Chuck33079

I've screwed up painting mine twice now. I've got a set of Nismo wheels headed off to get painted soon, and I'll just throw the turn signals into the deal. Get it done right. I'm a retard with a rattlecan.

__________________
2011 MB Touring-Sport-6sp-Nav/GTM TT/FI TT TDX/JTran/Kosmic/Eibach/Hotchkis/SPC/CSF/RPS/SoThatsWhereAllMyMoneyWent

Mshayegan

Haha, ok thanks guys for your help

__________________
2010 Nissan 370z 40th Anniversary 'Black Edition'

JARblue

Well, I actually purchased a second set from a forum member who sold his Z. I did several coats on them, and they came out super dark. It wasn't exactly what I wanted, but I thought it looked fine. I even removed all the tape very cautiously, and the lines were very clean. Of course, then during the install, I dropped one of them on the concrete, scratching the hell out of it. So I pulled off my stock original ones and did the single coat, and thought it looked great. Then I got antsy and didn't take my time removing the tape and a couple of edges peeled. I've been getting a lot more practice over the past year, so I'm much better with the rattle can. I'm going to get some more KAD paint and color match a lot more of the silver trim on the interior. It's a subtle change, but I like it a lot.

__________________

Troyz

You know what the Z stands for? Now how could you think of desecrating it with Batman?

JARblue

They are very easy to remove. In fact, I remove them every time I wax the car. Just slide your fingernail under the front edge of the marker and push it towards the back of the car. Once you push it far enough so a clip will clear the edge of the hole in the fender, the front of the marker should pop out. Then just pull it forward to release the rear clip.

Here is my album. There's not much detail because it's really easy to do. Nissan 370Z Forum - JARblue's Album: Side Markers

__________________