Trolley Jack question

MX52Z · 07-03-2013, 01:31 PM

BTW, For the HF jack owners (maybe everyone too), I spotted this new cross-beam attachment for our jacks. Floor Jack Cross Beam

I haven't checked it out in person yet nor measured it compared to the Z but it looks interesting.

Stino · 07-03-2013, 03:16 PM

Quote:

Originally Posted by MX52Z

BTW, For the HF jack owners (maybe everyone too), I spotted this new cross-beam attachment for our jacks. Floor Jack Cross Beam

I haven't checked it out in person yet nor measured it compared to the Z but it looks interesting.

I purchased the cross-beam. It doesn't work because the thickness of the beam and jack are way to high.

Jimc · 07-03-2013, 03:51 PM

I ended up get the 2.5 T at HF. Minimum height is like 3"'s but works fine. Wanted the 2 T but they were out of stock. Ended up jacking one side at a time to install the spacers, but need to find to old posts that show the center jacking point for front and rear. Tend to agree with some of the other posts, going to need to drive up on a couple of 2X10's.

Thanks

Jim

JARblue · 07-03-2013, 03:55 PM

Quote:

Originally Posted by Jimc

Ended up jacking one side at a time to install the spacers, but need to find to old posts that show the center jacking point for front and rear. Tend to agree with some of the other posts, going to need to drive up on a couple of 2X10's.

Thanks

Jim

Here's a link to the center jack points (front and rear). This thread has a lot of good info regarding jacking up the Z as well

Using Jack Stand...where to contact point?

07-03-2013, 03:51 PM	#3 (permalink)
Jimc Base Member Join Date: May 2013 Location: New Jersey Age: 75 Posts: 97 Drives: 12 Vert Tour BS M6 Rep Power: 12	Thanks for all the info I ended up get the 2.5 T at HF. Minimum height is like 3"'s but works fine. Wanted the 2 T but they were out of stock. Ended up jacking one side at a time to install the spacers, but need to find to old posts that show the center jacking point for front and rear. Tend to agree with some of the other posts, going to need to drive up on a couple of 2X10's. Thanks Jim

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Jack Stand Question	spearfish25	Nissan 370Z General Discussions	143	10-16-2015 11:30 AM
Actual picture of 370z supported by jack stands on all 4 side jack pionts.	gsxr750	Nissan 370Z General Discussions	2	10-28-2012 02:42 PM
Jack Stands / Floor Jack	ronaldr911	Exterior & Interior	31	01-10-2012 01:50 PM
1/8th jack?	Xell	Exterior & Interior	1	06-14-2011 08:06 PM
Jack stand placement question.	Soygen	Nissan 370Z General Discussions	2	05-27-2010 05:54 PM

07-03-2013, 01:31 PM	#1 (permalink)
MX52Z Enthusiast Member Join Date: Dec 2012 Location: Port Charlotte, FL Posts: 471 Drives: Z'less por ahora Rep Power: 13	BTW, For the HF jack owners (maybe everyone too), I spotted this new cross-beam attachment for our jacks. Floor Jack Cross Beam I haven't checked it out in person yet nor measured it compared to the Z but it looks interesting.