Help? How to make NA power on z370 m6.

Originally Posted by SS_Firehawk

Maybe you don't understand at all. Unless you dyno'd every single part you installed by its self, you will not know what you gained. So your numbers are irrelevant. There is only so much you can do for bolt on power with NA. Every single option has been used and documented here. So explain to me how I don't get it?

If you read everyone's posts, your logic is the butt of jokes. At least a few of us tried to help. I'm all for your motivation to mod, but it would be in your best interest to not insult people who give you accurate advice. You think all those mods and numbers are going to equal a 100+whp improvement? So I say again, 1+1 does not equal 2.

And to save yourself some time, nearly all aftermarket exhausts will make similar power as the other. Same for cold air intakes. HFC's come in 200 and 300 CEL count, 200 is less restrictive. PPE and Fast Intentions are the only Long tube headers available. Every shorty header isn't worth it except the Momentum headers. Motordyne intake manifold only gives mid range power with minimal loss up top. No need for ignition amplifier, the car uses direct ignition. No need to grounding kit, you car is new. Pulley's make 5-7whp. And buy yourself an oil cooler. Looking at your previous posts, Whiteline sway bars are preferred over the hotchkis by most, The twin supercharger kit is going to cost you $14,000+ install not including supporting mods. The stock LSD sucks. SS lines, new pads, rotors, and fluid, your brakes will be boss.

Unless your building the bottom end and/or getting exhaust cams, there is not much else to know about NA mods. Welcome to the money pit.