How much have u put up with ur 370z?

XwChriswX

I have a 2010 Z, built before 6/20 (Not sure what the difference is between before/after 6/20 builds but anyways) and have had (knock on wood) Zero issues with the Steering lock...

Is it something that if I took it to the dealer and explained quite a few Z's have had this issue, can you/will you do something about it so that I don't have to worry about this?

Or is it something that can only be fixed when it breaks?

__________________

Bonnie - Stage 2, Audio build coming this fall!
R.I.P. Abby 3/29/10 - 3/30/14

Baer383

Dealers only fix things when they break b/c they have to send back the defective parts.

__________________
2013 ZL1

754 rwhp 747 rwtq

XwChriswX

Damn, I was hoping there was a TSB or something we could walk in with and get it comp'd.

__________________

Bonnie - Stage 2, Audio build coming this fall!
R.I.P. Abby 3/29/10 - 3/30/14

svt to 370z

k so let me get this straight there is a steering lock fuse issue and a steering lock failure issue which both can be prevented if I take the fuse out and do the harness fix it yourself?

onzedge

You "fix" it by either of these approaches, not both.

__________________

Koni|Swift|Michelin|Motordyne|Berk|RJM Performance|Gates|SPL|Motul|Technafit|Ate Super Blue|Hawk
Tommy Kaira|Momo|Optima|Hella|Hotchkis|Red Line|ZSpeed|Stillen|B&M|H&R

Felix 808

The Fix for them was to stop using them mid to late 2011 . There are the bypass kits out there though, but pulling the fuse is the easy solution

__________________
Semper Fi

Μολὼν λαβέ

Cmike2780

I still don't understand why it isn't covered under your warranty unless you only have the remaining power-train....and not the extended bumper to bumper. Was the car and/or warranty purchased through a Nissan dealership? If it wasn't, then you're shyt out of luck and will have to bite the bullet until Nissan finally does a recall. This is kind of the risk involved when buying any used car...especially a sports car. Parts and repairs will cost more than you think and something will break eventually. This is pretty much the reason why I bought a then new Z instead of a used Porsche....plus an extended warranty. A higher price tag has nothing to do with overall reliability. Even Ferraris and Lambos break down.

__________________

[09][MB][6-Spd MT][Touring][Stillen Gen III][K&N][Borla CBE][Evo-R]

marks370z

My '12 has something wrong with trunk hatch release where as I click it once and it pops slightly but doesn't unlock so I have to click it again to get it to unlock fully then kind of have to force it up, very minimally, but enough to where it feels like I shouldn't have to be doing it.

Then again I'm either too lazy or it doesn't bother me enough to get it fixed.

__________________

Baer383

My 13 Nismo did the same thing check the black plungers on the hatch mine were not installed right,I reinstalled them now it works fine.

__________________
2013 ZL1

754 rwhp 747 rwtq

Cmike2780

there was a TSB for it, but not sure if it applies to the Nismo or '12. It's mainly because of the little springs Baer mentioned. Try repositioning or have the dealer replace them. They're like $30 each.

__________________

[09][MB][6-Spd MT][Touring][Stillen Gen III][K&N][Borla CBE][Evo-R]

marks370z

I kid you not, I went out to my Z and looked at the plungers and they looked to me to be facing outwards, so I just turned them around and bam it works.

Thanks for that!

__________________

SurfDog

I *hate* being stranded, but I admid that I also love upgrading broken parts. So far I've stayed ahead of the breakdown curve by pre-replacing all the stuff that commonly fails.
-aftermarket clutch slave. (did the master at same time just to be sure)
-pulled steering lock fuse first thing
-upgraded clutch and flywheel my 25k used clutch seemed burnt when I bought the car.
-have oil cooler on order
-thinking of upgrading the rear diff to something more bulletproof.

so far no breakdowns, but you are right, it takes a little getting used to a car that tends to break more than a DD.

I always tell myself mechanical failures are a good chance to upgrade weak systems...
otherwise maybe I'd be driving a camery or something.

__________________
09 6spd Berk CBE, JWT cams, ZSpeed CSC, Stillen (25 row oil, brake cooling, sways, gen3 CAI), Passport (9500ci), Quaife LSD, Z1 400 hp kit, ss lines, pads, rotors, clutch etc, Phunk's pan and fuel starve fix

SurfDog

somewhere around here is a DIY hatch fix using a couple pennies as spacers.

my hatch needs help sometimes too, but its not annoying enough that ive fixxed it.

__________________
09 6spd Berk CBE, JWT cams, ZSpeed CSC, Stillen (25 row oil, brake cooling, sways, gen3 CAI), Passport (9500ci), Quaife LSD, Z1 400 hp kit, ss lines, pads, rotors, clutch etc, Phunk's pan and fuel starve fix

OldGuy

Do it yourself or have your corner mechanic do it. My Nissan dealer estimated $200. My corner mechanic friend, who changes my oil and does my inspections, did it in 7 minutes and, when I asked I much I owed, he said, "Don't worry about it. Have a good day."
'Nuff said.

SurfDog

Im no mechanic and I "fixxed" it myself.

all you do is turn on the car so the lock disengages, then pull the fuse (There is a ton of how to threads on how to do it exactly)

your settring lock will not reingage and the microswsitch which tells the starter starter logic it is okay to start will be permenantly pressed.

3 fixes. you can:
1. pull the fuse (very easy)(reccomended)
2. install wire kit (more complecated as you have to wait for the part)
3. Cut the brown wire (much like pulling the fuse but a bit more permenant)

there are at least 5 threads describing this very easy (5minute) fix.

I reccomend pulling your fuse (it is reversable and very very easy to do even for a total non mechanic.)

__________________
09 6spd Berk CBE, JWT cams, ZSpeed CSC, Stillen (25 row oil, brake cooling, sways, gen3 CAI), Passport (9500ci), Quaife LSD, Z1 400 hp kit, ss lines, pads, rotors, clutch etc, Phunk's pan and fuel starve fix