Crush Washer?

SINISTER · 03-23-2017, 08:23 PM

Quote:

Originally Posted by vtec to vvel

For those that DIY oil changes, whenever you replace the copper o-ring on the drain plug, do you have a hard time getting it to go all the way down? Most of the time, it will go down to the second to last thread, but not completely down to the bottom of the bolt?

If you twist it on you can get it right to the bottom..but it yea second to last thread is pretty much right there.

ZoomZ · 04-24-2017, 01:06 PM

There is the right way and then there's the service manual way.

Note Image at top left. *1 and note C. Where 'C' is stated as oil pan side.

Oil pan 50.jpg

ZoomZ · 04-24-2017, 01:11 PM

So what's the torque on the Titek Magnetic plug? and Can I use the Nissan Copper washer with it?

Z1 says 17 Ft.lb for theirs, so I think that's probably be good for Titek. (since both are aluminum) I'm thinking even 19 Ft.lb would be ok.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Oil change question crush washer	zeddreaming	DIY Section (Do-It-Yourself)	4	01-22-2017 10:38 PM
HFC with the ability to use the factory crush ring?	Neo187H	Intake/Exhaust	3	07-13-2012 12:34 PM
Crush gasket needed?	SlikNik	Nissan 370Z General Discussions	17	07-20-2010 04:35 PM
Oil Drain Plug Crush Washer-Stupid Question	rmorrow	Nissan 370Z General Discussions	4	07-09-2010 08:03 PM
Prius, VW Crush Tesla In Green Car Violence	AK370Z	Other Vehicles	7	10-28-2009 01:35 PM

04-24-2017, 01:06 PM	#32 (permalink)
ZoomZ Track Member Join Date: Jan 2017 Location: Vancouver, BC Posts: 766 Drives: 17' 370Z Nismo Rep Power: 40618	There is the right way and then there's the service manual way. Note Image at top left. *1 and note C. Where 'C' is stated as oil pan side. Oil pan 50.jpg

04-24-2017, 01:11 PM	#33 (permalink)
ZoomZ Track Member Join Date: Jan 2017 Location: Vancouver, BC Posts: 766 Drives: 17' 370Z Nismo Rep Power: 40618	So what's the torque on the Titek Magnetic plug? and Can I use the Nissan Copper washer with it? Z1 says 17 Ft.lb for theirs, so I think that's probably be good for Titek. (since both are aluminum) I'm thinking even 19 Ft.lb would be ok.