What did you do with your Z today V (ON TOPIC DISCUSSION ONLY)

chrischhorn · 07-21-2013, 05:00 PM

Quote:

Originally Posted by Z_ealot

when i changed out my diff oil on my last Z the dealer had about a few hundred of the diff gaskets in stock so im betting the odds are very good

Here in Hawaii, I had to order them.......lol. Took 5 days for them to come in

dmhenderson · 07-21-2013, 05:53 PM

Dropped her off at the shop for the supercharger install this week.

GaleForce · 07-21-2013, 06:15 PM

Quote:

Originally Posted by blackcherry20

thanks Gale!!

you too chrischhorn

good information...
I hope I'm not driving it hard enough, often enough to need a replace on the CSC.

Don't forget about the elevenses you were doing that would put some wear on the poor plastic CSC.

pL4tiNumfi5t · 07-22-2013, 02:10 AM

Installed some GTMat Quadro in my trunk today. Not the cleanest job, but quieting down some of the cabin noise from my exhaust/HFC combo.

axmea? · 07-22-2013, 02:10 AM

Took off my lip for re-taping and actually liked how it looked without it. So it is off for now. Got me thinking of other lip options so I am now on the hunt. Ings +1 on top of the list, followed by Top Secret, and the Varis on third. It's just so many.

blackcherry20 · 07-22-2013, 06:30 AM

Quote:

Originally Posted by GaleForce

Don't forget about the elevenses you were doing that would put some wear on the poor plastic CSC.

LOL! I didn't forget. THat was the exception though, not the norm.
especially since I just had the new tires installed...haven't laid any 11s (other than at autoX) since then. No more playing...

kenchan · 07-22-2013, 10:50 AM

so yesterday i had to redo my dinoc around the hvac trim.

last time i used one sheet to wrap the entire trim and it looked great until the
summer sun hit it with in-cabin temps reaching over 120F.

i had to use a lot of tension when i wrapped around the hvac rings so that is
part of the reason why this happened.

this time i did the trim using 4 pieces. the main base piece, then 3 hvac
rings.

here's the base piece and the center ring attached. the center ring is only for
cosmetics to add consistency to the other 2 rings.

here are the side pieces that go on the outer hvac rings. i used masking tape
to make a template. this has no tension on the dinoc so it shouldn't peel up
or wrinkle later.

here are the side pieces attached..

and this time im heat cycling it under my IR lamp at 125F for 10hrs.

chrischhorn · 07-22-2013, 03:30 PM

Quote:

Originally Posted by kenchan

so yesterday i had to redo my dinoc around the hvac trim.

last time i used one sheet to wrap the entire trim and it looked great until the
summer sun hit it with in-cabin temps reaching over 120F.

i had to use a lot of tension when i wrapped around the hvac rings so that is
part of the reason why this happened.

( Click to show/hide )

Looks great. I'm not big into the CF interior wrap but you definitely did a nice job. I've seen peoples that look just flat out terrible and can't get the curves on it all that great.

kenchan · 07-22-2013, 03:36 PM

Quote:

Originally Posted by chrischhorn

Looks great. I'm not big into the CF interior wrap but you definitely did a nice job. I've seen peoples that look just flat out terrible and can't get the curves on it all that great.

Thanks!

yah, it does takes some playing to figure out this material. Wish it was thinner and a lot stickier.

ShutokuZ · 07-22-2013, 06:14 PM

Same here, I am not a fan of carbon anywhere, but that sir looks awesome!

Waiz · 07-22-2013, 08:16 PM

My Z is currently at the shop undergoing a facelift

I haven't seen her for 4 days, really starting to miss her

Quote:

Originally Posted by kenchan

Thanks!

yah, it does takes some playing to figure out this material. Wish it was thinner and a lot stickier.

I tried to go with the vinyl wrap on my center console and just didn't like how it came out so I painted it instead.

That stuff was such a PITA to work with

axmea? · 07-22-2013, 08:55 PM

Quote:

Originally Posted by Waizzz

My Z is currently at the shop undergoing a facelift

I haven't seen her for 4 days, really starting to miss her

Can't wait to see her Waizzz. She gonna be ready this w/e?

jlo370z · 07-22-2013, 09:33 PM

barnstorming bbq run yesterday

Pintsize725 · 07-22-2013, 09:34 PM

Quote:

Originally Posted by pL4tiNumfi5t

Installed some GTMat Quadro in my trunk today. Not the cleanest job, but quieting down some of the cabin noise from my exhaust/HFC combo.

Yay! Please let me know how quiet your ride is now.

FairladyZ10PG · 07-22-2013, 11:03 PM

Fedex came by my house to drop this off this afternoon.

07-21-2013, 05:53 PM	#5387 (permalink)
dmhenderson A True Z Fanatic Join Date: Feb 2011 Location: Maryland Posts: 5,930 Drives: AWD TT 370z Rep Power: 26	Dropped her off at the shop for the supercharger install this week. Waiz, onzedge, forza370z and 5 others like this. __________________

07-22-2013, 02:10 AM	#5389 (permalink)
pL4tiNumfi5t Base Member Join Date: Nov 2010 Location: 520, AZ Posts: 120 Drives: 2020 Tacoma TRD Pro Rep Power: 14	Installed some GTMat Quadro in my trunk today. Not the cleanest job, but quieting down some of the cabin noise from my exhaust/HFC combo. b15, JARblue, Pintsize725 and 3 others like this. __________________ Tanabe Medalion Touring w/Y-Pipe \| Berk HFCs \| Mishimoto Air Intake Kit \| aFe Pro Dry S Drop-ins \| EcuTek \| Z1 34R Oil Cooler \| RS-R Ti2000 \| KONI Yellow \| SPL \| Goodridge Phantom \| Kics \| GTMat \| WedsSport SA-55M \| Bridgestone S-04 DIY: 7AT Aux Power Outlet Relocate

07-22-2013, 02:10 AM	#5390 (permalink)
axmea? A True Z Fanatic Join Date: Apr 2012 Location: SoCal Posts: 6,235 Drives: WELL ZED PW 6MT Rep Power: 53241	Took off my lip for re-taping and actually liked how it looked without it. So it is off for now. Got me thinking of other lip options so I am now on the hunt. Ings +1 on top of the list, followed by Top Secret, and the Varis on third. It's just so many. Waiz, DEpointfive0 and blackcherry20 like this. __________________ >MyZ's Album< NISMO Convert/ECUTEK/Takeda CAI/F.I. HFC NR CB Carbon/F.I. 34 Row Oil Cooler/4.08 Final Drive /Powertrix+Swifts/Hotchkis/SPL/Whiteline/TWM/Zoom Engineering/EVO-R/AeroJacket Vented CF Fenders + CF Spoiler/Avant Garde-WORK/NST/Morimoto Halo/STi Clear Lenses/Carbon Signal Automotive/RJM Performance/ZSpeed Clutch Flywheel CSC delete

07-22-2013, 10:50 AM	#5392 (permalink)
kenchan A True Z Fanatic Join Date: Aug 2009 Location: N/A Posts: 76,801 Drives: N/A Rep Power: 141521	so yesterday i had to redo my dinoc around the hvac trim. last time i used one sheet to wrap the entire trim and it looked great until the summer sun hit it with in-cabin temps reaching over 120F. i had to use a lot of tension when i wrapped around the hvac rings so that is part of the reason why this happened. this time i did the trim using 4 pieces. the main base piece, then 3 hvac rings. here's the base piece and the center ring attached. the center ring is only for cosmetics to add consistency to the other 2 rings. here are the side pieces that go on the outer hvac rings. i used masking tape to make a template. this has no tension on the dinoc so it shouldn't peel up or wrinkle later. here are the side pieces attached.. and this time im heat cycling it under my IR lamp at 125F for 10hrs. chrischhorn, axmea? and Shadezz like this.

07-22-2013, 06:14 PM	#5395 (permalink)
ShutokuZ Track Member Join Date: Oct 2012 Location: Honolulu Posts: 512 Drives: 2013 PW 6MT Sport Rep Power: 14	Same here, I am not a fan of carbon anywhere, but that sir looks awesome! kenchan likes this.

07-22-2013, 09:33 PM	#5398 (permalink)
jlo370z Im a Fireball Join Date: Apr 2012 Location: Ill in noise Posts: 3,370 Drives: 11 370z Red 6spd Rep Power: 43426	barnstorming bbq run yesterday onzedge, axmea?, blackcherry20 and 1 others like this. __________________ ❝The Jlo370Z Build❞ 523HP \| 455 ftb tq \| 11.5 PSI \| 93 Octane *2017 Porsche 991.2 C4!l*

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
5D3 Discussion	FrancoPhoto	Photography	6	07-09-2012 01:08 AM
[Off Topic,GTA]Who dares to drive in the snow tonight with their Z?	Da.Menace	Canada	11	02-05-2011 06:43 PM
Double Din Dvd/Nav Feedback Topic	Carbon_z	Audio & Video	7	11-19-2010 12:10 PM
on the topic of oil ??	sonic370	Nissan 370Z General Discussions	5	07-17-2010 10:50 PM
Lounge (Off Topic) Rules	AK370Z	The Lounge (Off Topic)	0	09-23-2008 08:19 PM