If your car has never gone above 250 degrees? you're good to go. The second i see over 250? I'd consider one. If you're not competing in any sport and
|
|
LinkBack | Thread Tools | Display Modes |
07-29-2012, 12:24 PM | #16 (permalink) |
A True Z Fanatic
Join Date: Jul 2009
Location: ny'r livn in tx
Posts: 8,687
Drives: well over 130m.p.h.
Rep Power: 14858 |
If your car has never gone above 250 degrees? you're good to go. The second i see over 250? I'd consider one. If you're not competing in any sport and haven't been aggressive enough on the car to get high oil temps. cooler not needed. On the street you can control oil temps with good throttle control and a high quality synthetic. Without my cooler i was able to drop oil temps by making sure the car steady cruises no higher than 2,750rpm. inside of 10-15 min, you'll drop 10-20 degrees. You can drive this car hard and not hit limp mode if you take cool down laps or rides. But if you're seriously competing... The oil cooler is a must. There is no cool down lap in a competition till it's all said and done.
I have one cuz i drive hard... really hard. |
07-30-2012, 07:04 AM | #17 (permalink) |
Track Member
Join Date: Feb 2012
Location: 10aC
Posts: 978
Drives: Taco
Rep Power: 76 |
Installed a 25 row from Z1 Motorsports this weekend and am happy with the results. Was hitting 250-260 in southern MD when we were getting high 90s outside. Install took about 5 hours in my driveway.
|
07-30-2012, 12:21 PM | #19 (permalink) |
Track Member
Join Date: Feb 2012
Location: 10aC
Posts: 978
Drives: Taco
Rep Power: 76 |
Actually I have to say this is one of the few installs I've done on vehicles that went without any hiccups. It seems there is always something that goes wrong or what not. Peice of cake with this one, tho
I posted up a DIY in this morning if you want to look it over and there are a few other ones in that section that helped me out as well. |
07-30-2012, 01:07 PM | #20 (permalink) | |
Enthusiast Member
Join Date: May 2011
Location: PA
Posts: 362
Drives: MB Roadster (sold)
Rep Power: 14 |
Quote:
For a street car if you are < 230 in the hot you are fine. Folks who track there cars have different thermal requirements and its a good investment. 100 deg, AC on, and my 2010 never goes above 225. I see temps creep up 5deg during stop and go while the HW seems to be steady at 220 in the very warm. < 80 deg and normal temps are 210-215F. I run 5/30 Pennzoil Ultra, FWIW. - b |
|
07-30-2012, 01:20 PM | #21 (permalink) | |
A True Z Fanatic
Join Date: Oct 2010
Location: NA
Posts: 1,732
Drives: NA
Rep Power: 22 |
Quote:
|
|
07-30-2012, 01:43 PM | #22 (permalink) | |
A True Z Fanatic
Join Date: Jul 2009
Location: ny'r livn in tx
Posts: 8,687
Drives: well over 130m.p.h.
Rep Power: 14858 |
Quote:
|
|
07-30-2012, 03:27 PM | #23 (permalink) |
Enthusiast Member
Join Date: Mar 2011
Location: Miami
Posts: 357
Drives: 2011 - Nissan 370 M6
Rep Power: 14 |
Isnt 180 -190 temps on the really cold side for normal every day driving? An oil cooler is really meant if you track your car but its NOT needed if you use your car for normal commuting. Hell, even if you drive a little spirited, yes, you may go over 220 to perhaps 240 MAYBE even 250 but how long can you drive "spiritedly" and not have to come to a full stop on the streets? traffic lights, other cars, pedestrians LOL. Your car will have time to cool off again. It takes only a few minutes for it to come back down in temps.
This engine is meant to be hot, the spark plugs are designed to run hot, the engine is designed to run hot. The oil is designed to provide optimum protection at temperatures above 200. Otherwise, you are risking premature wear and engine sludge build up. Over time, this will lead to higher emmissions, lower MPGs, lower engine performance and throttel response. You can try to put a plate infront of your oil cooler to keep it from cooling too much and take it off when you go to the tracks. |
07-30-2012, 05:49 PM | #24 (permalink) |
Track Member
Join Date: Feb 2012
Location: 10aC
Posts: 978
Drives: Taco
Rep Power: 76 |
I think we should complement this discussion with a debate of which oil should be used with an oil cooler.
So I'l bite. Link to where credible,scientific data shows 180-190 is bad for the oil and 220 is the sweet spot for this engine? |
07-30-2012, 06:21 PM | #26 (permalink) |
Track Member
Join Date: Feb 2012
Location: 10aC
Posts: 978
Drives: Taco
Rep Power: 76 |
I haven't seen anything to state that either, Davey. just a lot of folks spouting off something they heard from a friend who knows a mechanic who heard it on the interwebs.
Me, I sleep good that the oil is a little cooler and if I sludge the hell out of the internals or blow the engine I promise to post it up. |
07-30-2012, 06:29 PM | #27 (permalink) |
A True Z Fanatic
Join Date: Dec 2010
Location: Dallas, TX
Posts: 18,504
Drives: like it's stolen
Rep Power: 107 |
__________________
Clarification #1: I'm not a bro... [FONT="Garamond"]♥ Baby Zilla ♥ ~ Instagram: @SxZnS Forgestar | FAST INTENTIONS | Berk | Injen | H&R | SPC | Seibon | |
07-30-2012, 06:30 PM | #28 (permalink) |
A True Z Fanatic
Join Date: Oct 2010
Location: Cartersville, Ga
Age: 32
Posts: 2,570
Drives: '15 RR, '14 IS250
Rep Power: 31 |
Anything under 300 degrees is pussy shit.
Just kidding, but honestly if there wasn't a gauge right in front of our face I don't think half the people would have an oil cooler. Just my two cents though. |
07-30-2012, 06:39 PM | #29 (permalink) | |
A True Z Fanatic
Join Date: Jun 2011
Location: Madison, WI
Posts: 1,397
Drives: 2009 370Z
Rep Power: 16804 |
Quote:
However, I think the issue would be immediately present if I track my car. Lengths are longer and turns are wider, which would mean I'd be on the throttle much more and usually all the way down. This would be why it'd be good to install a cooler. |
|
07-30-2012, 07:10 PM | #30 (permalink) | |
A True Z Fanatic
Join Date: Oct 2009
Location: LA. not L.a.
Posts: 21,652
Drives: Z34 Tour/Sport
Rep Power: 178 |
Quote:
The only reason they didn't have a oil temp problem in the 350 was because.....no oil temp gauge. The same goes for many many other vehicles, no gauge no problem.
__________________
"These Violent Delights Have Violent Ends" |
|
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DIY: Stillen 19 Row Oil Cooler Install - driver side (stock PS cooler unmoved) | djpathfinder | DIY Section (Do-It-Yourself) | 21 | 11-30-2015 06:47 AM |
Nissan Motorsports Oil Cooler vs. Stillen Oil Cooler | Dustin@Z1 | Engine & Drivetrain | 158 | 03-10-2014 03:27 PM |
[FOR SALE] AT Transmission Cooler with Setrab 19 Row cooler | zakimak | Parts for sale (Private Classifieds) | 4 | 03-03-2012 12:44 PM |
Oil cooler orientation (Z1 cooler) | BrandonT | Engine & Drivetrain | 10 | 05-23-2011 09:26 AM |
Oil Cooler.....Trans Cooler... | kannibul | Engine & Drivetrain | 6 | 12-31-2009 07:32 PM |