Tell me about it. Damn you 160 pixel avatar limit!!!
|
|
LinkBack | Thread Tools | Display Modes |
05-08-2012, 12:53 PM | #46 (permalink) |
A True Z Fanatic
Join Date: Feb 2009
Location: Northern VA
Posts: 55,385
Drives: on two wheels
Rep Power: 6962 |
Tell me about it. Damn you 160 pixel avatar limit!!!
__________________
- Steve Zs & Coffee - Saturdays at 10AM in Fairfax, VA and Columbia, MD (Click the banner!) LIKE us on Facebook! |
05-08-2012, 12:58 PM | #47 (permalink) | |
A True Z Fanatic
Join Date: Jun 2009
Location: californee way
Posts: 5,380
Drives: 370, Leaf
Rep Power: 30 |
You have a point and you might well be right, but I am not certain if the difference is as big as people seem to think. I have done laps at 200F/220F/240F and 260F. My datalogger shows no noticeable difference in acceleration between any of the laps with corner exit at the same speed. The difference between them is so small that I am not sure if it does anything on the road. A few HP, I would buy in, but the car isn't going from 330HP to 230HP.
I mean I wish I didn't have to spend $700 on a new oil cooler, but I think Nissan would take care of most of the complains by putting in a oil pressure gauge instead of temperature. Quote:
|
|
05-08-2012, 01:17 PM | #49 (permalink) | |
A True Z Fanatic
Join Date: Jul 2009
Location: The Ark
Posts: 2,357
Drives: '09 370z
Rep Power: 21 |
Quote:
I think the temp difference is more pronounced down low because you have less power available down there. Like 6th gear at 2k RPM's where you would only have maybe 200hp available instead of the full 332hp. I definitely agree it is not losing some 100hp due to oil temp though. We would all be driving lemons then. As far as the $700 oil cooler, I think I am going to Modshack's route and just build my own except go ahead and get stainless lines and use a 34 row unit instead of the 24 he used. |
|
05-08-2012, 01:23 PM | #52 (permalink) |
A True Z Fanatic
Join Date: Feb 2009
Location: Northern VA
Posts: 55,385
Drives: on two wheels
Rep Power: 6962 |
__________________
- Steve Zs & Coffee - Saturdays at 10AM in Fairfax, VA and Columbia, MD (Click the banner!) LIKE us on Facebook! |
05-08-2012, 02:01 PM | #55 (permalink) |
A True Z Fanatic
Join Date: Feb 2012
Location: Northern California
Posts: 1,424
Drives: 370Z Touring/Sport
Rep Power: 16 |
I will put a happy face sticker over the Oil temp gauge, then i don't have to read it...
I will keep the tank full of gasoline... I will change the Oil at regular intervals...Screw checking it...The 350Z never needed it, so I won't care about the 370Z Oil...It blows, they change the engine...On their dime.. Road noise , the 350Z was the same way.. So for me, I have solved all my problems...
__________________
2009 Sport/Touring 370Z 1971 Z/28 with coil overs, rushforth's, willwoods, Hotchkis. 4 speed GMC Sierra1500 |
05-08-2012, 04:35 PM | #58 (permalink) | |
A True Z Fanatic
Join Date: Apr 2010
Location: .
Posts: 42,608
Drives: .
Rep Power: 3886 |
Quote:
The brake issue is very cheap do deal with. Better braking fluid is affordable, and pads are affordable depending on budget. You may run into a problem if driving the car for long enough. The oil cooler is a little pricey, but not bad. This issue can creep up in everyday life. On a hot enough day, in bumper to bumper traffic, or if you're out for a spirited drive... What I did before my oil cooler install was just to keep my eye on the gauge, and if you're starting to push 250 degrees, just dial back on the spirited driving. Cruise for a bit and find a place to stop. But again, these are fairly uncommon occurrences. It is simply better to be wary of them than blind to the possibility. |
|
05-08-2012, 05:01 PM | #59 (permalink) |
Track Member
Join Date: Jul 2010
Location: Sandy Hook, CT
Posts: 972
Drives: Nissan 370z Nismo
Rep Power: 16 |
I agree OP. The only complaint i truly have is that my car has 5,500 miles on it and I have these rattles that I now have to take apart the panels and find!!! But thats it... lol
__________________
Fast Intentions CF Exhaust - Fast Intentions HFC's - HPS Tubes w/ AFE Dry Flow Filter's |
Bookmarks |
|
|