Dealer recommends I get an oil cooler?

onzedge · 09-06-2011, 10:33 AM

Quote:

Originally Posted by PapoZalsa

I will have to search but I beleive this what Nissan says either about the oil cooler or something related to that. It was in a thread were they gave the Part Number for the oil cooler and at the end BOOM!....the statement about the warranty.

But I might be wrong....

I confirmed with 2 dealers that adding an oil cooler does not impact warranty. Addition of an oil pan spacer does void it -- a cooler does not. This is, of course, assuming that the oil cooler itself is not the cause of a failure.

Red__Zed · 09-06-2011, 10:43 AM

Quote:

Originally Posted by onzedge

I confirmed with 2 dealers that adding an oil cooler does not impact warranty. Addition of an oil pan spacer does void it -- a cooler does not. This is, of course, assuming that the oil cooler itself is not the cause of a failure.

Nissan north America refuses to issue a statement either way. Until then, it's discretionary. NNA may refuse to reimburse a dealer for the costs if they don't approve, and if you don't have it in writing, no dealer is going to eat that cost.

Red__Zed · 09-06-2011, 10:46 AM

Quote:

Originally Posted by cossie1600

if your gf wears panties, do you do the same too? not all cars are designed equal. if the engine is made with larger piston ring tolerence, it makes absolutely no difference. if anything, you can go back and argue not to overcool. oil are safe to go 260+ and 300+ on synthetic, not sure what everyone is whining about. put some 3m tape on the oil temp gauge and drive

Wow, thanks. Had no clue that fixed limp mode.

cossie1600 · 09-06-2011, 11:01 AM

230 or 260 is not limp mode. dont peel off the tape until you hit it. you will be a lot happier

Red__Zed · 09-06-2011, 11:05 AM

Quote:

Originally Posted by cossie1600

230 or 260 is not limp mode. dont peel off the tape until you hit it. you will be a lot happier

I don't fret temps under 300. Limp mode gets in the way though.

onzedge · 09-06-2011, 11:06 AM

Quote:

Originally Posted by Red__Zed

Wow, thanks. Had no clue that fixed limp mode.

Quote:

Originally Posted by cossie1600

230 or 260 is not limp mode. dont peel off the tape until you hit it. you will be a lot happier

PapoZalsa · 09-06-2011, 01:16 PM

Quote:

Originally Posted by Red__Zed

Wow, thanks. Had no clue that fixed limp mode.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DIY: Stillen 19 Row Oil Cooler Install - driver side (stock PS cooler unmoved)	djpathfinder	DIY Section (Do-It-Yourself)	21	11-30-2015 05:47 AM
Nissan Motorsports Oil Cooler vs. Stillen Oil Cooler	Dustin@Z1	Engine & Drivetrain	158	03-10-2014 02:27 PM
Insurance renewal time - recommends in ATX	Kastley85891	Texas	7	08-30-2010 11:16 AM
Oil Cooler.....Trans Cooler...	kannibul	Engine & Drivetrain	6	12-31-2009 06:32 PM
Dealer Invoice at my dealer . .	TN370ZLC	Nissan 370Z Pricing / Ordering Discussions	8	03-17-2009 12:44 AM

09-06-2011, 11:01 AM	#64 (permalink)
cossie1600 A True Z Fanatic Join Date: Jun 2009 Location: californee way Posts: 5,380 Drives: 370, Leaf Rep Power: 30	230 or 260 is not limp mode. dont peel off the tape until you hit it. you will be a lot happier