Nissan 370Z Forum

Nissan 370Z Forum (http://www.the370z.com/)
-   Nissan 370Z General Discussions (http://www.the370z.com/nissan-370z-general-discussions/)
-   -   Z up on Jacks (http://www.the370z.com/nissan-370z-general-discussions/24148-z-up-jacks.html)

Cunnos 08-26-2010 02:13 PM

Z up on Jacks
 
So i was just perusing through the "storing the Z in winter" thread and I wanted some additional suggestions. My question is......Do I put the Z up on jacks off the ground for the winter (4 months ) or does that damage or cause harm? Also, if I do put it up on jacks, do I still have to inflate the tires to 40 psi?

510z 08-26-2010 02:23 PM

I have no idea about the jacks but if you want to ship it to AZ ill drive it around for you.

flashburn 08-26-2010 02:24 PM

Get these:
http://www.raceramps.com/images/flat...race-ramps.jpg

Flatstoppers ™ - For Long Term Vehicle Storage, Stops Flat Spots from Forming on your Tire during Storage! | RaceRamps.com your best solution for Lightweight Car Ramps!

Trips 08-26-2010 02:28 PM

Great suggestion flashburn.

You have been repped

Cunnos 08-26-2010 02:30 PM

These look like great products, but 259 for a set, seems kinda steep........thanks though I may consider

flashburn 08-26-2010 02:35 PM

I looked around and you can get them for around $230 at a few different places.

flashburn 08-26-2010 02:36 PM

Quote:

Originally Posted by Triple's (Post 695703)
Great suggestion flashburn.

You have been repped

Thanks! OG's represent!

FuszNissan 08-26-2010 02:37 PM

Or just put Nitrogen in the tires for $20

flashburn 08-26-2010 02:51 PM

Quote:

Originally Posted by FuszNissan (Post 695722)
Or just put Nitrogen in the tires for $20

Wouldn't you still run the risk of getting flat spots on the tires where they are sitting?

Red__Zed 08-26-2010 03:09 PM

Quote:

Originally Posted by flashburn (Post 695757)
Wouldn't you still run the risk of getting flat spots on the tires where they are sitting?

Yes you would.

texasviking 08-26-2010 03:50 PM

It seems like you could easily make these out of wood for the cost of 2 4x4x8' pieces of wood and some screws/glue...

1. Cut each 4x4x8' 8 equal length pieces
2. Make template that matches outer curvature of tire (including ramp and flat spot so you can drive up and into the dip)
3. Use a band saw to make the cuts
4. (Repeat 4x) - Attach 3 pieces together to make a 12" wide ramp

Edit: this would only use 12 of the 16 pieces... so if you NEEEED 16" wide ramps, just connect 4 pieces together :P

azn370z 08-26-2010 04:05 PM

When I left for NYC I left my prelude on 4 Jack stands for about 5 months. You should roll down the window and disconnect the battery. Or you may start the car every couple weeks.

daleks 08-26-2010 04:09 PM

Race Ramps products are nice, but indeed expensive. The stoppers shown there are for if you just want to drive up into the cup. I have the 2-piece wheel cribs (RR-WC-12-2) that are essentially the same thing, but you have to jack your car up to put the cribs under each tire. The 12" cribs are more expensive, but can be had for ~$135 if you Google the part number. There are even 8" cribs. BTW, I'm suggesting the 2-piece ones so you get a total of 4 components.

PapoZalsa 08-26-2010 09:04 PM

Too early for thinking about Winter!

I hate Winter!!!! :mad:

BeachZTT 08-26-2010 09:08 PM

Quote:

Originally Posted by flashburn (Post 695757)
Wouldn't you still run the risk of getting flat spots on the tires where they are sitting?

No, no, no... nitrogen is rounder than air. :)


All times are GMT -5. The time now is 09:36 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2