What did you do with your Z today

onzedge · 10-28-2011, 08:24 PM

Quote:

Originally Posted by pedelg24

Nice!

Is your Z lowered?

It will be lowered (Swift Spec-R) next Saturday. I need the Bridjit ramps first.

pedZ · 10-28-2011, 08:42 PM

Quote:

Originally Posted by onzedge

It will be lowered (Swift Spec-R) next Saturday. I need the Bridjit ramps first.

Doh. I had read that earlier and completely had a brain fart. Lol.

onzedge · 10-28-2011, 08:48 PM

Quote:

Originally Posted by pedelg24

Doh. I had read that earlier and completely had a brain fart. Lol.

Do not worry about it -- Brain-farts happen to be one of my fortes.

haitech · 10-28-2011, 10:17 PM

Quote:

Originally Posted by pedelg24

That sucks... Sorry to hear that.

Thanks a lot man. Seems like Nissan is still putting the wrong wheel locks even after 2 yrs.

pedZ · 10-28-2011, 10:21 PM

Quote:

Originally Posted by haitech

Thanks a lot man. Seems like Nissan is still putting the wrong wheel locks even after 2 yrs.

I would say that it to the dealer and have them fix their error but since you were installing spacers I have a feeling that they will try and blame that as the source of the problem.

christian370z · 10-28-2011, 10:24 PM

Took the Z out to a dinner that my friends threw me for my 21st last night, going to a party in the Hollywood Hills tonight (the Z is staying at school). I'm going to wash it tomorrow, most likely with a slight headache haha.

Alchemy · 10-28-2011, 10:32 PM

Quote:

Originally Posted by onzedge

It will be lowered (Swift Spec-R) next Saturday. I need the Bridjit ramps first.

About time!!! You are gonna love the Swifts! They are amazing.

onzedge · 10-28-2011, 10:43 PM

Quote:

Originally Posted by Alchemy

About time!!! You are gonna love the Swifts! They are amazing.

Yeah, yeah. It took me a while to decide on which springs (or coil-overs). The swifts and SPC rear camber arms are sitting in my garage, waiting patiently.

pedZ · 10-28-2011, 10:45 PM

Quote:

Originally Posted by christian370z

Took the Z out to a dinner that my friends threw me for my 21st last night, going to a party in the Hollywood Hills tonight (the Z is staying at school). I'm going to wash it tomorrow, most likely with a slight headache haha.

Happy Birthday!

happytheman · 10-28-2011, 10:52 PM

Ughh, had to pull into a parking lot today that was crazy steep..so much so that I worried I was going to scrape on the way in. Much to my chagrin I realized that there was no baxk way out....guess what? On the way out....scraaaaaape.

good thing it was only the chin spoiler.

If I wasn't at stock height, this would have been sooo much worse.

christian370z · 10-28-2011, 11:28 PM

Quote:

Originally Posted by happytheman

Ughh, had to pull into a parking lot today that was crazy steep..so much so that I worried I was going to scrape on the way in. Much to my chagrin I realized that there was no baxk way out....guess what? On the way out....scraaaaaape.

good thing it was only the chin spoiler.

If I wasn't at stock height, this would have been sooo much worse.

Tell me about it, I am so happy I bought my INGS+1 lip used and scraped since it scrapes on EVERYTHING. It makes me feel less guilty haha.

Alchemy · 10-28-2011, 11:41 PM

Quote:

Originally Posted by onzedge

Yeah, yeah. It took me a while to decide on which springs (or coil-overs). The swifts and SPC rear camber arms are sitting in my garage, waiting patiently.

As far as which springs to choose there should have been NO debate.

ZForce · 10-28-2011, 11:59 PM

Quote:

Originally Posted by onzedge

...Tomorrow --Bridjit curb ramp delivery. Next week, Swift Spec-R installation.

Been looking for something like this, the bro scrapes when entering the driveway, I do not at the point where I enter the driveway......but at $299. that is a bit steep.

https://www.bridjit.com/buy.php?1=1

Quote:

Originally Posted by onzedge

Mr. Kenchan is correct. I have lost 2 of them. For some reason, they are not stocked parts either. Go figure.

Odd...I have no problem with my dealer stocking these lil buggers.

Quote:

Originally Posted by onzedge

I will post pics. I bought only the two end pieces -- 8 feet total. My driveway is one car wide and very long (very old house).

So what did it run you for the two? Did you buy direct or Amazon?

I will have to make a drive by and test em with the lowered on swifts. Let me know when you have them up.

Quote:

Originally Posted by onzedge

Check this out -- Rhino Ramps with my shadetree mechanic, hillbilly, homemade helpers.

ok...I am either steal/beg/borrow yours when Taylor installs the oil cooler or have to break down and buy these beasties. Where did you pick em from?

btw: welcome to the Swift Club...about time, I hope you trashed the Eibachs.

ZForce · 10-29-2011, 12:03 AM

Washed both Z's today, yeh I am old skool....good ol water, MG's UW&W & UQW, microfibre mit and towels ...oh...the big bad boy MF towel that holds 2 gals of water before having to wring it out. Dressed the tires and checked the nitro in tires.

Ready for a coastal cruise with some friends tomorrow. Leaving at 6:00 am, 400 mile trek 9hrs on the road. Does it get any better than this?

Drove it tonight for some sushi

onzedge · 10-29-2011, 08:29 AM

Quote:

Originally Posted by ZForce

Been looking for something like this, the bro scrapes when entering the driveway, I do not at the point where I enter the driveway......but at $299. that is a bit steep.

https://www.bridjit.com/buy.php?1=1

Odd...I have no problem with my dealer stocking these lil buggers.

So what did it run you for the two? Did you buy direct or Amazon?

I will have to make a drive by and test em with the lowered on swifts. Let me know when you have them up.

ok...I am either steal/beg/borrow yours when Taylor installs the oil cooler or have to break down and buy these beasties. Where did you pick em from?

btw: welcome to the Swift Club...about time, I hope you trashed the Eibachs.

1. I bought the Bridjits directly from them -- 2 end pieces for $199.00 plus $50.00 freight. I ordered Thursday and they are delivering today. Not bad -- 2 days from Washington and a Saturday delivery.

2. Come by anytime to check the curb ramps out. Let me know and I will PM my address -- you could swing by on the way home from Davis no problem.

3. The Rhino ramps -- I picked them up at Tognatti's on El Camino but I have seen them at Pep Boys and AutoZone -- they are about $40.00 or so. I think they are 6,000 pound capacity and a great deal less than Race Ramps. The "hillbilly helper" boards are from Home Depot. A few minutes on the table saw and a few screws and I was good to go. I also drilled a hole in each to drop a bolt through to keep them in place on the ramps. The ramps have a little hole also near the end.

4. Taylor will do a nice job on the oil cooler for you. He and Colin did the install on mine last year as a Father's Day gift. What cooler are you getting? The GTM Motorsports unit I have serves me very well -- the lines they use are made by Setrab and are tested to 2,000 psi.

5. Next Saturday is the spring/camber arm installation and I am doing it at Colin's shop on Northgate so I can do the alignment right away. I get a hefty discount when I use them and it helps the shop out. I really did not want to do springs here at the house and then have to drive an unaligned car -- even a few miles.

6. I will have to go to the Nissan in Roseville for parts -- the local guys are more Altima/Versa oriented than Z-centric.

7. I never installed the Eibachs -- I sold them new-in-box.

8. That's all. Have a great weekend, Mr. ZForce.

10-28-2011, 10:24 PM	#7671 (permalink)
christian370z A True Z Fanatic Join Date: Jul 2010 Location: Newport Beach Posts: 3,900 Drives: 2010 370Z/Saab 900se Rep Power: 432	Took the Z out to a dinner that my friends threw me for my 21st last night, going to a party in the Hollywood Hills tonight (the Z is staying at school). I'm going to wash it tomorrow, most likely with a slight headache haha. __________________ -320whp / 259wftlbs- SP Rays -- RE-11s -- SpecialtyZ Tune -- Swift Springs -- Stillen 25R Oil Cooler -- Stillen G3 Intakes -- Berk HFCs -- F.I. 12" CBE -- Stillen Sway Bars -- Es14 Spring -- INGS+1 lip -- CF Spoiler -- GTR Start Button -- VLED Parking Lights -- PWJDM V2 shift knob Last edited by christian370z; 10-28-2011 at 10:27 PM.

10-28-2011, 10:52 PM	#7675 (permalink)
happytheman A True Z Fanatic Join Date: Apr 2010 Location: Florida Posts: 10,737 Drives: MB 6M Tour/Sport Z34 Rep Power: 1822	Ughh, had to pull into a parking lot today that was crazy steep..so much so that I worried I was going to scrape on the way in. Much to my chagrin I realized that there was no baxk way out....guess what? On the way out....scraaaaaape. good thing it was only the chin spoiler. If I wasn't at stock height, this would have been sooo much worse. __________________ --Brantly-- *PowderCoating by Mike/Stillen/PWJDM/Shine Auto/NST* GTR/Michelin /Fast Intentions/Evo-R/Mobil 1/Motul/Z1 https://facebook.com/CentralFloridaZClub

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Got Z? I did today!	dharvison	New 370Z Owner	17	12-14-2011 05:45 PM
Saw a GTR today	bigaudiofanat	The Lounge (Off Topic)	30	07-15-2011 06:14 PM
Today was the day!	NewYorkJon34	New 370Z Owner	4	06-23-2009 04:03 PM
Just got it Today 6/14/09 :D!!!!	COD4	New 370Z Owner	15	06-21-2009 05:22 PM
New as of today	prodigyz	New 370Z Owner	1	04-14-2009 01:42 AM

10-29-2011, 12:03 AM	#7679 (permalink)
ZForce A True Z Fanatic Join Date: Jul 2009 Location: Roseville, CA Posts: 2,359 Drives: 09 370Z Tour + Sport Rep Power: 21	Washed both Z's today, yeh I am old skool....good ol water, MG's UW&W & UQW, microfibre mit and towels ...oh...the big bad boy MF towel that holds 2 gals of water before having to wring it out. Dressed the tires and checked the nitro in tires. Ready for a coastal cruise with some friends tomorrow. Leaving at 6:00 am, 400 mile trek 9hrs on the road. Does it get any better than this? Drove it tonight for some sushi