06-03-2010, 07:05 PM
|
#11 (permalink)
|
|
Base Member
Join Date: May 2010
Location: SF bay area
Posts: 95
Drives: Car
Rep Power: 15
|
Quote:
Originally Posted by scruffydog
So, I'm stuck on trying to figure out the alignment tabs that protrudes out of the bumper, I need dimensions.....does that mean I need to take mine off?
I really don't want to do that....anyone already have their emblems off already and don't mind doing that for us? I can always design the emblem in a way where I can just over estimate the holes location or even counter sink bore a step circular shape on the rear side of the emblem....but I really prefer to be able to re-use those existing tabs for alignment as they're already there.
|
I wouldn't worry about it too much, we can just do it on the fly at my shop when were ready to get down on this. we'll make a prototype of the badges, and if they are acceptable only then will we need to remove any badges to dial in the exact fit.Then we'll make our copies and send them out for paint/plating/powder coat. Might have to roll badge-less for a week while they're out but it'll be worth it.
|
|
|
Similar Threads
Threaded Mode
